Page 1
Serial ATA Hard Drive Dock
eSATA USB to SATA External
Hard Drive Dock with USB Hub
and Card Reader
SATDOCKCRH
SATDOCKCRHGB
Instruction Manual
Page 2
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.•
Increase the separation between the equipment and receiver.•
Connect the equipment into an outlet on a circuit different from that to which the receiver •
is connected.
Consult the dealer or an experienced radio/TV technician for help.•
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only
and do not represent an endorsement of a product or service by StarTech.com, or an
endorsement of the product(s) to which this manual applies by the third-party company
in question. Regardless of any direct acknowledgement elsewhere in the body of
this document, StarTech.com hereby acknowledges that all trademarks, registered
trademarks, service marks, and other protected names and/or symbols contained in this
manual and related documents are the property of their respective holders.
Page 3
i
Table of Contents
Introduction ..................................................................... 1
Packaging Contents.....................................................................1
System Requirements .................................................................1
Front View ....................................................................................2
Rear View ....................................................................................2
Installation ....................................................................... 3
Hardware Installation ...................................................................3
Driver Installation .........................................................................3
Specifications .................................................................. 4
Technical Support ........................................................... 5
Warranty Information ...................................................... 5
Page 4
1
Introduction
The SATDOCKCRH/GB combines the convenience of a SATA hard
drive docking station with a 13-in-1 card reader and 2-port USB hub,
and can be connected to a computer through either USB or eSATA.
Packaging Contents
1 x SATDOCKCRH hard drive dock•
1 x eSATA cable•
1 x USB cable (A-B)•
1 x Power Adapter•
1 x Instruction Manual•
System Requirements
USB and/or eSATA enabled computer system•
Microsoft Windows•
®
2000/XP/Vista/7, Mac OS® X, or Linux
®
Page 5
2
eSATA
connector
USB
connector
Power
connector
Hard Drive slot
Drive Eject
button
USB hub
Card Reader slot
Power
button/LED
Front View
Rear View
Page 6
3
Installation
WARNING: Hard drives require careful handling, especially when
being transported. If you are not careful with your hard disk, lost data
may result. Always handle storage devices with caution.
Hardware Installation
Connect the external power adapter from the hard drive dock to a 1.
power outlet.
Insert a 2.5” or 3.5” hard drive into the top loading slot. Make sure 2.
that the connectors on the hard drive are facing the same corner of
the slot that has a cutout in the door. The label on the hard drive
should face the front of the hard drive dock.
Connect the USB cable and eSATA cable from the hard drive dock to 3.
the computer system.
NOTE: The hard drive dock can be used with only the USB connection,
if eSATA is not available on the computer system. The hard drive can
be used over eSATA alone, however to use the USB hub and/or card
reader, the USB must be connected.
Once all connections are made, press the power button on the top of 4.
the hard drive dock.
To remove the hard drive, make sure it is currently not being 5.
accessed by the computer then unmount or uninstall the disk drive
from the operating system (see documentation for your operating
system). Press the drive ejection button on the top of the hard drive
dock the release the drive. Then pull the drive from the slot.
Driver Installation
Windows 2000/XP/Vista/7, Mac OS X, Linux
No driver installation is required for these operating systems, as the
hard drive dock, USB hub and card reader are natively supported, so
the drivers are already installed.
Page 7
4
Specications
Bus Interface
USB 2.0
SATA 3.0Gb/s
Connectors
1 x USB type B
1 x eSATA
2 x USB type A
1 x SD/MMC/MS card slot
LEDs
1 x Power/Activity
Hard Drive Compatibility
2.5” or 3.5” SATA 1.5/3.0 Gb/s
hard drive up to 1.5TB capacity
Flash Card Compatibility
•MS/MSPro
•SD/MMC
•MSDuo,MSProDuo,MS
Pro-HG Duo
•RS-MMC
•SDHC
•MSMicro
•Mini-SD,Micro-SD
•Micro-SDHC
Maximum Data Transfer Rate
USB: 480 Mb/s
SATA: 3 Gb/s
Power Adapter
12VDC, 2.5A, center positive
Dimensions
145.0mm x 93.0mm x 65.0mm
Weight
413g
Compatible Operating
Systems
Windows 2000/XP/Vista/7,
Mac OS X, Linux
Page 8
5
Technical Support
StarTech.com’s lifetime technical support is an integral part of our
commitment to provide industry-leading solutions. If you ever need
help with your product, visit www.startech.com/support and access
our comprehensive selection of online tools, documentation, and
downloads.
Warranty Information
This product is backed by a one year warranty.
In addition, StarTech.com warrants its products against defects in
materials and workmanship for the periods noted, following the initial
date of purchase. During this period, the products may be returned
for repair, or replacement with equivalent products at our discretion.
The warranty covers parts and labor costs only. StarTech.com does
not warrant its products from defects or damages arising from misuse,
abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA
LLP (or their officers, directors, employees or agents) for any damages
(whether direct or indirect, special, punitive, incidental, consequential, or
otherwise), loss of profits, loss of business, or any pecuniary loss, arising
out of or related to the use of the product exceed the actual price paid
for the product. Some states do not allow the exclusion or limitation of
incidental or consequential damages. If such laws apply, the limitations
or exclusions contained in this statement may not apply to you.
Page 9
StarTech.com has been making “hard-to-find easy” since 1985,
providing high quality solutions to a diverse IT and A/V customer
base that spans many channels, including government, education
and industrial facilities to name just a few. We offer an unmatched
selection of computer parts, cables, A/V products, KVM and Server
Management solutions, serving a worldwide market through our
locations in the United States, Canada, the United Kingdom and
Taiwan.
Visit www.startech.com today for complete information about all
our products and to access exclusive interactive tools such as the
Cable Finder, Parts Finder and the KVM Reference Guide.
Loading...