Page 1
Serial ATA Hard Drive
Mobile Rack
3.5” Trayless SATA Mobile Rack
for Dual 2.5” Hard Drives
SATDOCK2520
Instruction Manual
Page 2
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.•
Increase the separation between the equipment and receiver.•
Connect the equipment into an outlet on a circuit different from that to which the receiver •
is connected.
Consult the dealer or an experienced radio/TV technician for help.•
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only
and do not represent an endorsement of a product or service by StarTech.com, or an
endorsement of the product(s) to which this manual applies by the third-party company
in question. Regardless of any direct acknowledgement elsewhere in the body of
this document, StarTech.com hereby acknowledges that all trademarks, registered
trademarks, service marks, and other protected names and/or symbols contained in this
manual and related documents are the property of their respective holders.
Page 3
i
Table of Contents
Introduction ..................................................................... 1
Packaging Contents.....................................................................1
System Requirements .................................................................1
Front View ....................................................................................2
Rear View ....................................................................................2
Installation ....................................................................... 3
Hardware Installation ...................................................................3
Driver Installation .........................................................................3
How to Use ...................................................................... 4
Specifications .................................................................. 5
Technical Support ........................................................... 6
Warranty Information ...................................................... 6
Page 4
1
Introduction
This 3.5” trayless SATA Mobile Rack allows you to install two 2.5”
SATA drives in an available/unused 3.5” floppy drive bay. Featuring a
convenient trayless “easy eject” feature (like a tape cartridge or floppy
disk), the hard drive bay doesn’t require that the drives be installed into
a tray - making it the ideal solution for quick and easy drive removals
and insertions as part of a system building process, or integration into
rackmount systems or industrial environments.
Packaging Contents
1 x SATDOCK2520 hard drive backplane•
1 x Package of mounting screws•
2 x Keys•
2 x 18” 7-pin SATA cable•
1 x Instruction Manual•
System Requirements
9.5mm 2.5” SATA 1.5/3.0 Gbps hard drive(s)•
An available external 3.5” bay in the computer case•
SATA enabled computer system•
Page 5
2
Door Lock
Power/Activity
LED
15-pin SATA
power
7-pin SATA
connector
Front View
Rear View
Page 6
3
Installation
WARNING: Hard drives require careful handling, especially when
being transported. If you are not careful with your hard disk, lost data
may result. Always handle your hard drive and storage device with
caution.
Hardware Installation
Make sure the computer system is powered off and unplugged from 1.
the power source before attempting any hardware installation.
Locate an available external 3.5” floppy drive bay on the 2.
computer case and install the Mobile Rack appropriately. See
the documentation for your computer case for installation details.
Mounting screws are included, if necessary.
Connect two 7-pin SATA cable from the back of the Mobile Rack to 3.
the SATA port in the computer system.
Connect the 15-pin SATA power cable from the computer power 4.
supply to the Mobile Rack.
Pull on the metal tabs/hinge on the front of the Mobile Rack to open 5.
the drive bay doors. Insert a SATA hard drive into the drive bay
(label facing up) and close the door behind it, making sure it latches
properly.
OPTIONAL: Use the included keys to lock the front door to prevent
accidental/unauthorized access to the hard drive(s).
Power up the computer and use the hard drive(s) as if connected 6.
directly to the SATA controller/motherboard.
Driver Installation
No driver installation is required for any operating system, as this
Mobile Rack is a pass through device, so only the hard drives are seen
by the computer system.
Page 7
4
How to Use
If the SATA controller supports Hot-Swapping drives, then hard drives
can be removed and installed into the Mobile Rack without having to
shut the computer system off. Refer to the documentation for the SATA
controller for details on how to use Hot-Swapping. If not supported, the
computer must be shut down first, to install or remove hard drives.
To remove hard drives from the Mobile Rack, unlock the front drive bay
door (if necessary) with the provided keys and open the door by pulling
on the metal latch. Swing the door fully open and the drive will be
ejected, and can then be pulled out of the drive bay by hand.
Page 8
5
Specications
Bus Interface
SATA 3.0Gb/s
External Connectors
2 x 7-pin SATA
1 x 15-pin SATA power
LEDs
Power/Activity
Hard Drive Compatibility
9.5mm 2.5” SATA 1.5/3.0 Gbps
hard drives up to 500GB in
capacity*
Insertion Rating
15 000 cycles
Operating Temperature
5oC to 70oC
Storage Temperature
-40oC to 80oC
Humidity
8 - 90% RH
Dimensions
154.0mm x 101.0mm x 25.0mm
Weight
224g
The unit will only support SATA hard drive capacities supported by *
the SATA controller, up to a maximum of 500GB.
Page 9
6
Technical Support
StarTech.com’s lifetime technical support is an integral part of our
commitment to provide industry-leading solutions. If you ever need
help with your product, visit www.startech.com/support and access
our comprehensive selection of online tools, documentation, and
downloads.
Warranty Information
This product is backed by a one year warranty.
In addition, StarTech.com warrants its products against defects in
materials and workmanship for the periods noted, following the initial
date of purchase. During this period, the products may be returned
for repair, or replacement with equivalent products at our discretion.
The warranty covers parts and labor costs only. StarTech.com does
not warrant its products from defects or damages arising from misuse,
abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA
LLP (or their officers, directors, employees or agents) for any damages
(whether direct or indirect, special, punitive, incidental, consequential, or
otherwise), loss of profits, loss of business, or any pecuniary loss, arising
out of or related to the use of the product exceed the actual price paid
for the product. Some states do not allow the exclusion or limitation of
incidental or consequential damages. If such laws apply, the limitations
or exclusions contained in this statement may not apply to you.
Page 10
StarTech.com has been making “hard-to-find easy” since 1985,
providing high quality solutions to a diverse IT and A/V customer
base that spans many channels, including government, education
and industrial facilities to name just a few. We offer an unmatched
selection of computer parts, cables, A/V products, KVM and Server
Management solutions, serving a worldwide market through our
locations in the United States, Canada, the United Kingdom and
Taiwan.
Visit www.startech.com today for complete information about all
our products and to access exclusive interactive tools such as the
Cable Finder, Parts Finder and the KVM Reference Guide.
Loading...