StarTech.com SAT3510U2VGB, SAT3510U2VEU, SAT3510BU2V, SAT3510BUVGB, SAT3510BUVEU Instruction Manual

Page 1
Manual Revision: 12/15/2011
For the most up-to-date information, please visit: www.startech.com
DE: Bedienungsanleitung - de.startech.com FR: Guide de l'utilisateur - fr.startech.com ES: Guía del usuario - es.startech.com IT: Guida per l'uso - it.startech.com NL: Gebruiksaanwijzing - nl.startech.com PT: Guia do usuário - pt.startech.com
SAT3510U2V / SAT3510U2VGB / SAT3510U2VEU SAT3510BU2V / SAT3510BUVGB / SAT3510BUVEU
3.5in Silver USB 2.0 to SATA External Hard Drive Enclosure
*actual product may vary from photos
Page 2
Instruction Manual
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other protected names and/or symbols of third-party companies not related in any way to StarTech.com. Where they occur these references are for illustrative purposes only and do not represent an endorsement of a product or service by StarTech.com, or an endorsement of the product(s) to which this manual applies by the third-party company in question. Regardless of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby acknowledges that all trademarks, registered trademarks, service marks, and other protected names and/or symbols contained in this manual and related documents are the property of their respective holders.
Page 3
Instruction Manual
i
Table of Contents
Introduction ............................................................................................1
Packaging Contents .................................................................................................................................1
System Requirements .............................................................................................................................. 1
Hardware Guide .....................................................................................2
Front Panel View ........................................................................................................................................2
Rear Panel View .......................................................................................................................................... 2
Installation ..............................................................................................3
Hardware Installation .............................................................................................................................. 3
Driver Installation ...................................................................................................................................... 6
Specications ..........................................................................................7
Technical Support ..................................................................................8
Warranty Information ............................................................................8
Page 4
Instruction Manual
1
Introduction
Thank you for purchasing a StarTech.com SAT3510U2V / SAT3510BU2V InfoSafe 3.5” USB 2.0 SATA Aluminum Hard Drive Enclosure. This cost-eective storage solution suits a wide variety of applications including le and application sharing between desktop and notebook computers, data archiving, or simply backing up existing hard drives to preserve data security.
Packaging Contents
• 1 x Aluminum HDD Enclosure
• 1 x USB (A-B) Cable
• 1 x Screw Kit
• 1 x Plastic Stand
• 1x Power Adapter
• 1 x Instruction Manual
System Requirements
• 3.5” SATA hard drive
• An available (nearby) power outlet
• A host PC or Mac computer system with an available USB port
• Mac OS 9.0 and up, and Linux
Page 5
Instruction Manual
2
Hardware Guide
Front Panel View
Power/Activity LED
Power/Activity LED
Rear Panel View
Power Adapter
Port
On/O Switch
USB type B
Port
Screw Kit
Power Adapter
USB A-B Cable
Plastic Stand
Page 6
Instruction Manual
3
Installation
WARNING! Hard drives and storage enclosures require careful handling, especially when being transported. If you are not careful with your hard disk, lost data may result. Always handle your hard drive and storage device with caution. Be sure that you are properly grounded by wearing an anti-static strap when handling computer components or discharge yourself of any static electricity build-up by touching a large grounded metal surface (such as the computer case) for several seconds.
Hardware Installation
1. Remove the Rear Panel, to expose the internal SATA connections:
2. Position the hard drive you wish to install such that the SATA connection is facing towards the SATA interface connector provided by the Enclosure’s front panel:
Page 7
Instruction Manual
4
3. With the hard drive connected to the front panel, turn the drive over to expose it’s base. Fasten the hard drive to the front panel rails on both sides, using the screws provided (2):
4. Fasten the front panel (with drive attached) to the body of the Enclosure; be cautious that the drive and front panel are properly aligned with the body of the Enclosure, to prevent damage to the LEDs.
Page 8
Instruction Manual
5
5. Fasten both sides of the case to lock the hard drive in place:
6. Fasten the rear panel to the Drive Enclosure on both sides using the screws (2) provided.
Page 9
Instruction Manual
6
7. Once the drive has been secured within the Enclosure, connect the DC 12V power adapter to the power adapter port. Connect the remaining end of the power adapter to an available power outlet.
8. Connect the USB A-B cable to the USB B port on the rear panel of the Enclosure, then connect the remaining end of the cable to the host computer.
9. With the host computer powered on, power on the Drive Enclosure using the On/ O switch. The operating system will detect the presence of the added drive, following which you will be able to properly format/partition the installed drive from within the operating system.
Driver Installation
No driver installation is required for the supported operating systems, as this enclosure is natively supported, so the drivers are already installed.
Page 10
Instruction Manual
7
Specications
Bus Type USB 2.0
Chipset SunPlus SPIF301
Maximum Date Transfer Rate 480 Mbps
LED Indicators
Solid Green -Power status
Blinking Green - Read/Write Drive
Activity
Enclosure Casing Material Aluminum
Power Adapter 12V DC, 2000mA
Dimensions (L x W x H)
193 mm x 113 mm x 31 mm
(7.6” x 4.45” x 1.22”)
Weight 325 g (11.47 oz )
OS Compatibility
Mac OS 9.0 and up, and Linux, Windows
2000 / Windows 2003 / Windows 7 /
Windows 98SE / Windows ME / Windows
XP
Page 11
Instruction Manual
8
Technical Support
StarTech.com’s lifetime technical support is an integral part of our commitment to provide industry-leading solutions. If you ever need help with your product, visit www.startech.com/support and access our comprehensive selection of online tools, documentation, and downloads.
For the latest drivers/software, please visit www.startech.com/downloads
Warranty Information
This product is backed by a two year warranty.
In addition, StarTech.com warrants its products against defects in materials and workmanship for the periods noted, following the initial date of purchase. During this period, the products may be returned for repair, or replacement with equivalent products at our discretion. The warranty covers parts and labor costs only. StarTech.com does not warrant its products from defects or damages arising from misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their ocers, directors, employees or agents) for any damages (whether direct or indirect, special, punitive, incidental, consequential, or otherwise), loss of prots, loss of business, or any pecuniary loss, arising out of or related to the use of the product exceed the actual price paid for the product. Some states do not allow the exclusion or limitation of incidental or consequential damages. If such laws apply, the limitations or exclusions contained in this statement may not apply to you.
Page 12
Hard-to-nd made easy. At StarTech.com, that isn’t a slogan. It’s a promise.
StarTech.com is your one-stop source for every connectivity part you need. From the latest technology to legacy products — and all the parts that bridge the old and new — we can help you nd the parts that connect your solutions.
We make it easy to locate the parts, and we quickly deliver them wherever they need to go. Just talk to one of our tech advisors or visit our website. You’ll be connected to the products you need in no time.
Visit www.startech.com for complete information on all StarTech.com products and to access exclusive resources and time-saving tools.
StarTech.com is an ISO 9001 Registered manufacturer of connectivity and technology parts. StarTech.com was founded in 1985 and has operations in the United States, Canada, the United Kingdom and Taiwan servicing a worldwide market.
Loading...