StarTech.com POESPLT100 User Manual

POEINJ100

POESPLT100

Instruction Manual

Power over Ethernet

10/100 POE Power over Ethernet

Injector - 48V

10/100 POE Power over Ethernet

Splitter - 5V/12V

Manual Revision:05/06/2011

For the most up-to-date information, please visit www.startech.com

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Use of Trademarks, Registered Trademarks, and other Protected Names and
Symbols

This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes
only and do not represent an endorsement of a product or service by
StarTech.com, or an endorsement of the product(s) to which this manual applies by
the third-party company in question. Regardless of any direct acknowledgement
elsewhere in the body of this document, StarTech.com hereby acknowledges that
all trademarks, registered trademarks, service marks, and other protected names
and/or symbols contained in this manual and related documents are the property
of their respective holders.

Table of Contents

Introduction .............................................................. 1

Packaging Contents.............................................................1

System Requirements ......................................................... 1

Side View - POEINJ100 .......................................................2

Side View - POESPLT100 ................................................... 2

Installation ................................................................ 3

POEINJ100.......................................................................... 3

POESPLT100 ......................................................................3

Specifications ........................................................... 4

Technical Support .................................................... 6

Warranty Information ............................................... 6

i

Introduction

The POEINJ100 10/100 Mbps device converts standard 90-260V AC
power into low-voltage DC power that can run over existing Cat5 or higher
network cable to power IEEE 802.3af/at compliant network devices, or the
POESPLT100 PoE Splitter.

The POESPLT100 splitter device separates the data and power
connections received from the Injector device and offers a selectable 5,

7.5, 9 or 12V output switch allowing you to customize the power output
to suit your requirements. Taking advantage of PoE technology lets you
expand your technology infrastructure without the hassle or expense of
running new electrical wiring.

Packaging Contents

POEINJ100 POESPLT100

1 x PoE injector 1 x PoE splitter

1 x Power Adapter 1 x Power Output cable

1 x Instruction Manual 1 x Instruction Manual

System Requirements

• RJ45 terminated Cat5 or higher Ethernet cabling

• 10/100 Mbps compatible Ethernet network

• Available AC power outlet for the POEINJ100 unit

1

Side View - POEINJ100

Side View - POESPLT100

2

Installation

POEINJ100

This should be the side that does not require Power over Ethernet.

1. Connect the Ethernet cable from the source network device (i.e.

computer, router, switch, etc) to the “Data (In)” RJ45 connector on the
input side of the POEINJ100 unit.

2. Connect the included power adapter to the POEINJ100 unit.

3. Connect an RJ45 terminated Ethernet cable to the “Power + Data (Out)”

connector on the output side of the POEINJ100 unit. The other end of
the cable will either connect directly to a PoE compliant device, or to the
POESPLT100 in order to separate data and power again.

POESPLT100

1. Connect the Ethernet cable from the POEINJ100 unit to the “Data +

Power (In)” RJ45 connector on the input side of the POESPLT100 unit.

2. Set the slide switch on the side of the unit to the desired voltage output

(5V, 7.5V, 9V, 12V).

3. Connect an RJ45 terminated Ethernet cable from the “Data (Out)”

connector on the output side of the POESPLT100 to the network device
(i.e. computer, router, switch, etc).

4. Connect the included Power Output Cable from the “Output Power”

connector on the output side of the POESPLT100 unit to the DC power
connector on the network device.

3

Specications

Compliant Standards

Connectors

LEDs

PoE Output

Link Speeds

Maximum Cable Length

Power Adapter

Operating Temperature

Storage Temperature

Humidity

Dimension (LxWxH)

Weight

POEINJ100

IEEE 802.3af
IEEE 802.3at

IEEE 802.3

IEEE 802.3u

2 x RJ45 Ethernet female

1 x DC Power type N

2 x RJ45 Link

48VDC, 30W

10/100 Mbps

100 m / 330 ft

48VDC, 880mA, type N plug

0°C ~ 40°C (32°F ~ 104°F)

-20°C ~ 85°C (-4°F ~ 185°F)

10% ~ 90% RH

102.0mm x 75.0mm x 23.0mm

490 g

4

Compliant Standards

Connectors

LEDs

PoE Input

Power Output

Link Speeds

Operating Temperature

Storage Temperature

Humidity

Dimension (LxWxH)

Weight

POESPLT100

IEEE 802.3af
IEEE 802.3at

IEEE 802.3

IEEE 802.3u

2 x RJ45 Ethernet female

1 x DC Power type N

1 x RJ45 Link

48VDC, 30W

5 / 7.5 / 9 / 12V DC,

up to 19.2W peak

10/100 Mbps

0°C ~ 45°C (32°F ~ 113°F)

-20°C ~ 90°C (-4°F ~ 194°F)

10% ~ 90% RH

102.0mm x 75.0mm x 23.0mm

240 g

5

Technical Support

StarTech.com’s lifetime technical support is an integral part of our
commitment to provide industry-leading solutions. If you ever need
help with your product, visit www.startech.com/support and access
our comprehensive selection of online tools, documentation, and
downloads.

Warranty Information

This product is backed by a one year warranty.
In addition, StarTech.com warrants its products against defects in

materials and workmanship for the periods noted, following the initial
date of purchase. During this period, the products may be returned
for repair, or replacement with equivalent products at our discretion.
The warranty covers parts and labor costs only. StarTech.com does
not warrant its products from defects or damages arising from misuse,
abuse, alteration, or normal wear and tear.

Limitation of Liability

In no event shall the liability of StarTech.com Ltd. and StarTech.
com USA LLP (or their officers, directors, employees or agents) for
any damages (whether direct or indirect, special, punitive, incidental,
consequential, or otherwise), loss of profits, loss of business, or any
pecuniary loss, arising out of or related to the use of the product exceed
the actual price paid for the product. Some states do not allow the
exclusion or limitation of incidental or consequential damages. If such
laws apply, the limitations or exclusions contained in this statement
may not apply to you.

6

StarTech.com has been making “hard-to-find easy” since 1985,
providing high quality solutions to a diverse IT and A/V customer
base that spans many channels, including government,
education and industrial facilities to name just a few. We offer
an unmatched selection of computer parts, cables, A/V products,
KVM and Server Management solutions, serving a worldwide
market through our locations in the United States, Canada, the
United Kingdom and Taiwan.

Visit www.startech.com today for complete information about
all our products and to access exclusive interactive tools such as
the Cable Finder, Par ts Finder and the KVM Reference Guide.