Page 1
Ethernet to DVI Video
Adapter
Ethernet to DVI Video Adapter
over IP
IP2DVI
Instruction Manual
Page 2
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.•
Increase the separation between the equipment and receiver.•
Connect the equipment into an outlet on a circuit different from that to which the receiver •
is connected.
Consult the dealer or an experienced radio/TV technician for help.•
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only and
do not represent an endorsement of a product or service by StarTech.com, or an endorsement of the product(s) to which this manual applies by the third-party company in
question. Regardless of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby acknowledges that all trademarks, registered trademarks,
service marks, and other protected names and/or symbols contained in this manual and
related documents are the property of their respective holders.
Page 3
i
Table of Contents
Introduction ..................................................................... 1
Packaging Contents.....................................................................1
System Requirements .................................................................1
Installation ....................................................................... 1
Hardware Installation ...................................................................1
Driver Installation .........................................................................2
Display mode ................................................................... 7
Specifications .................................................................. 8
Technical Support ........................................................... 9
Warranty Information ...................................................... 9
Page 4
1
Introduction
Packaging Contents
1 x IP2DVI video adapter•
1 x Power Adapter•
1 x Driver and Software CD•
1 x Instruction Manual•
System Requirements
DVI enabled monitor/projector•
TCP/IP network access•
Microsoft Windows•
®
XP/Vista (32-bit)
Installation
Hardware Installation
LAN Port
LAN Link
Indicator
Power Indicator
DVI Connector
Reset Button
Power
Connector
Page 5
2
LED Indicator
LED Colour Description
Power Red
ON: receiving power from adapter
OFF: no power supplied from adapter
Link Green
ON: network connection detected
OFF: no network connection detected
Flashing: data transfer
Driver Installation
Windows XP
Insert the provided CD into your disc drive. Locate and double-click 1.
the Setup.exe file in the Driver folder to launch the setup program.
During the installation, the screen may flicker a couple of times. This 2.
is normal. When this section of the installation is complete, click
‘Finish’ to proceed.
Page 6
3
When the ‘Install DisplayLink Software’ screen appears. Accept the 3.
terms in the license agreement to proceed.
If you have a firewall enabled on the computer, make sure to unblock 4.
the Cat5ShareStation utility.
Connect the IP2DVI unit to your router/switch and power it on.5.
When the Found New Hardware Wizard screen appears, select 6.
‘Install the software automatically (Recommended)’ and click Next.
Click ‘Finish’ to complete the installation. 7.
Launch the Cat5ShareStation utility from the icon on the Desktop.8.
A list of all available IP2DVI units detected on the network will 9.
appear.
Page 7
4
Select ‘Generic DoIP’ and click the ‘Connect’ button. When the 10.
connection is ready, you will see the Generic DoIP icon become
orange as below.
Then a pop-up message will appear in the notification area 11.
indicating the installation is complete.
If your monitor is not yet connected to the IP2DVI, make the 12.
connection and power on your monitor.
After the connection, the remote monitor should display an image 13.
from the computer.
Page 8
5
Windows Vista
Insert the provided CD into your disc drive. Locate and double-click 1.
the Setup.exe file in the Driver folder to launch the setup program.
During the installation, the screen may flicker a couple of times. This 2.
is normal. When this section of the installation is complete, click
‘Finish’ to proceed.
When the ‘Install DisplayLink Software’ screen appears. Accept the 3.
terms in the license agreement to proceed.
Page 9
6
After the installation completes, select Yes to restart your computer.4.
Connect the IP2DVI unit to your router/switch and power it on.5.
Launch the Cat5ShareStation utility from the icon on the Desktop. 6.
Click ‘unblock’ when you see the Windows Security Alert or other
firewall warning.
Select ‘Generic DoIP’ and click the ‘Connect’ button. When the 7.
connection is ready, you will see the Generic DoIP icon become
orange as below.
A pop-up message will appear in the notification area indicating the 8.
installation is complete.
If your monitor is not yet connected to the IP2DVI, make the 9.
connection and power on your monitor.
After the connection, the remote monitor should display an image 10.
from the computer.
Page 10
7
Display Mode
To change the display mode, right-click on the tray icon located in the
System Tray, next to the clock.
The IP2DVI connected monitor can be configured to:
Extend your Windows desktop (default)
Extend your Windows desktop to Right / Left / Above / Below the
primary display
Mirror your Windows desktop
On Windows XP
On Windows Vista
Page 11
8
Specications
External Connectors
1 x RJ45 female
1 x DVI-I 29-pin female
LEDs
1 x Power (red)
1 x LAN Link (green)
Maximum Resolution
1280 x 1024
Supported Colour Depth
16 and 32 bit
Supported Display Modes
Extended Desktop (left/right/•
above/below)
Mirrored (Cloned) Desktop•
Power Adapter
AC: 100-240V, 50-60Hz
DC: 5V, 2.5A
Operating Temperature
10 - 40 degrees
Storage Temperature
-10 - 80 degrees
Dimensions
97.0mm x 69.8mm x 20.8mm
Weight
83 g
Compatible Operating
Systems
Windows® XP/Vista (32-bit)
Page 12
9
Technical Support
StarTech.com’s lifetime technical support is an integral part of our commit-ment to provide industry-leading solutions. If you ever need help
with your product, visit www.startech.com/support and access our comprehensive selection of online tools, documentation, and downloads.
Warranty Information
This product is backed by a one year warranty.
In addition, StarTech.com warrants its products against defects in
materials and workmanship for the periods noted, following the initial
date of purchase. During this period, the products may be returned for
repair, or replacement with equivalent products at our discretion. The
warranty covers parts and labor costs only. StarTech.com does not warrant its products from defects or damages arising from misuse, abuse,
alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com
USA LLP (or their officers, directors, employees or agents) for any damages (whether direct or indirect, special, punitive, incidental, consequential, or otherwise), loss of profits, loss of business, or any pecuniary loss,
arising out of or related to the use of the product exceed the actual price
paid for the product. Some states do not allow the exclusion or limitation
of incidental or consequential damages. If such laws apply, the limitations or exclusions contained in this statement may not apply to you.
Page 13
StarTech.com has been making “hard-to-find easy” since 1985,
providing high quality solutions to a diverse IT and A/V customer
base that spans many channels, including government, education
and industrial facilities to name just a few. We offer an unmatched
selection of computer parts, cables, A/V products, KVM and Server Management solutions, serving a worldwide market through our
locations in the United States, Canada, the United Kingdom and
Taiwan.
Visit www.startech.com today for complete information about all
our products and to access exclusive interactive tools such as the
Cable Finder, Parts Finder and the KVM Reference Guide.
Loading...