eSATA ExpressCard Adapter
ECESATA22
Instruction Manual
Actual product may vary from photo
2 Port ExpressCard eSATA2 Drive Controller Card
FFCCCC CCoommpplliiaannccee SSttaatteemmeenntt
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
UUssee ooff TTrraaddeemmaarrkkss,, RReeggiisstteerreedd TTrraaddeemmaarrkkss,, aanndd
ootthheerr PPrrootteecctteedd NNaammeess aanndd SSyymmbboollss
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only and
do not represent an endorsement of a product or service by StarTech.com, or an
endorsement of the product(s) to which this manual applies by the third-party company in
question. Regardless of any direct acknowledgement elsewhere in the body of this
document, StarTech.com hereby acknowledges that all trademarks, registered
trademarks, service marks, and other protected names and/or symbols contained in this
manual and related documents are the property of their respective holders.
Instruction Manual
i
TTaabbllee ooff CCoonntteennttss
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Before You Begin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
System Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Installation and usage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Verifying successful driver installation . . . . . . . . . . . . . . . . . . . . . . . . .2
Connecting eSATA drives to the ExpressCard . . . . . . . . . . . . . . . . . . .2
Removing the connected drive . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Removing the ExpressCard from the computer . . . . . . . . . . . . . . . . . .3
Accessory Products from StarTech.com . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Technical Support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Warranty Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Instruction Manual
1
Thank you for purchasing a StarTech.com Two Port eSATA ExpressCard Adapter. This
product allows notebook users to experience the high performance capability of eSATA
storage, providing up to 250Mbps bandwidth, as well as support for Native Command
Queue (NCQ) hard drives.
IInnttrroodduuccttiioonn
Features
BBeeffoorree YYoouu BBeeggiinn
•
Compliant with ExpressCard Specification 1.0 and ExpressCard 34 Form Factor
•
Works with SATA I and SATA II devices
•
Hot pluggable
•
One available ExpressCard Slot
System Requirements
•
Supports Windows 2000/XP/2003 Server/Vista
•
1 x 2 Port eSATA ExpressCard Adapter
Package Contents
•
1 x Driver CD
This package should contain:
•
Operating System: Windows® 2000/XP/2003/Vista
•
1 x User Manual
Instruction Manual
2
IInnssttaallllaattiioonn aanndd uussaaggee
To verify that the necessary software has been installed:
1. Right-click on My Computer and select Manage.
2. Choose Device Manager.
3. Left-click on the (+) symbol located next to SCSI and RAID controller.
4. Silicon Image SiI 3132 SATALink Controller should be displayed. Right-click on
this listing and select Properties. Under the General tab, you should see that This
device is working properly.
Connecting eSATA drives to the ExpressCard
To begin using your eSATA drive(s) with ECESATA22, simply insert the eSATA connector
provided by the peripheral or attached cable (not included with ECESATA22) into one of
the eSATA ports provided by the ExpressCard.
1. Insert the ExpressCard into an available ExpressCard / 54 or 34mm slot. Since this
card is hot-pluggable, this can be performed while the computer is on or off. Once
the card has been inserted, ensure the computer is powered, to proceed with
installation.
2. Windows will detect that the card has been inserted, and will prompt for driver
installation.
3. Insert the Drivers & Utility CD (included) into the CD/DVDROM drive, and browse to
D:\ Silicon Image/SIL3132/Windows. Press OK to confirm selection.
4. Press Next to continue the installation.
5. Follow the on screen instructions, clicking on Finish to conclude installation.
Verifying successful driver installation
WARNING: Do not disconnect any cables or power sources while the hard
drive is active. This can result in data loss and possible damage to the hard
drive. If you wish to remove the attached external storage, please see the
section entitled Removing the ExpressCard from the computer.
Instruction Manual
3
Removing the connected drive
1. Close all windows and quit all running applications that are stored on the drive or that
are using data stored on the drive.
2. Click on the Safely Remove Hardware icon in your system tray and select the
installed eSATA drive. This will terminate any communication between the host
computer and the drive, making it safe to remove. Once complete, Windows will
display a message when it is safe to disconnect the interface cable or turn off the
drive.
Removing the ExpressCard from the computer
To remove the ExpressCard from the computer, gently pull the card from the
ExpressCard slot.
Instruction Manual
4
ESATAPLATE1
1 ft eSATA Data Internal to External Slot Plate
SATA2ESATA6
6 Ft Shielded External eSATA to SATA Cable M/M
ESATA6
6' Shielded External eSATA Cable M/M
ESATCASE2
Dual 3.5" Drive eSATA to SATA HD Enclosure
AAcccceessssoorryy PPrroodduuccttss ffrroomm SSttaarrTTeecchh..ccoomm
Contact your local StarTech.com dealer or visit www.startech.com for cables or other
accessories that will help you get the best performance out of your new product.
ESATA3
3 Ft Shielded External eSATA Cable M/M
PEX2EC
PCI-Express to ExpressCard Adapter
Instruction Manual
5
TTeecchhnniiccaall SSuuppppoorrtt
StarTech.com’s lifetime technical support is an integral part of our commitment to provide
industry-leading solutions. If you ever need help with your product, visit
www.startech.com/support and access our comprehensive selection of online tools,
documentation, and downloads.
WWaarrrraannttyy IInnffoorrmmaattiioonn
This product is backed by a lifetime warranty. In addition, StarTech.com warrants its
products against defects in materials and workmanship for the periods noted, following
the initial date of purchase. During this period, the products may be returned for repair, or
replacement with equivalent products at our discretion. The warranty covers parts and
labor costs only. StarTech.com does not warrant its products from defects or damages
arising from misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their
officers, directors, employees or agents) for any damages (whether direct or indirect,
special, punitive, incidental, consequential, or otherwise), loss of profits, loss of business,
or any pecuniary loss, arising out of or related to the use of the product exceed the
actual price paid for the product. Some states do not allow the exclusion or limitation of
incidental or consequential damages. If such laws apply, the limitations or exclusions
contained in this statement may not apply to you.
SSppeecciiffiiccaattiioonnss
Bus Type ExpressCard
Connectors 2 x eSATA
Maximum Data Transfer Rate 3.0 Gbps
OS Support Windows® 2000/XP/2003/Vista
Regulatory Certifications
CE, FCC, ROHS
Revised: 1 March 2007 (Rev. A)
AAbboouutt SSttaarrTTeecchh..ccoomm
StarTech.com is “The Professionals’ Source for Hard-to-Find Computer
Parts”. Since 1985, we have been providing IT professionals with the
quality products they need to complete their solutions. We offer an
unmatched selection of computer parts, cables, server management
solutions and A/V products and serve a worldwide market through our
locations in the United States, Canada, the United Kingdom and Taiwan.
Visit www.startech.com for complete information about all our products
and to access exclusive interactive tools such as the Parts Finder and the
KVM Reference Guide. StarTech.com makes it easy to complete almost
any IT solution. Find out for yourself why our products lead the industry in
performance, support, and value.
Loading...