1 Port ExpressCard to RS232 Serial Card
(USB Based)
EC1S232U2
*actual product may vary from photos
DE: Bedienungsanleitung - de.startech.com
FR: Guide de l'utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
IT: Guida per l'uso - it.startech.com
NL: Gebruiksaanwijzing - nl.startech.com
PT: Guia do usuário - pt.startech.com
For the most up-to-date information, please visit: www.startech.com
Manual Revision: 02/15/2012
Page 2
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of Trademarks, Registered Trademarks, and other Protected Names and
Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only and do not
represent an endorsement of a product or service by StarTech.com, or an endorsement of the
product(s) to which this manual applies by the third-party company in question. Regardless
of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby
acknowledges that all trademarks, registered trademarks, service marks, and other protected
names and/or symbols contained in this manual and related documents are the property of
their respective holders.
Technical Support ..................................................................................4
Warranty Information ............................................................................4
Instruction Manual
i
Page 4
Introduction
The EC1S232U2 1 Port ExpressCard RS232 Serial Adapter Card w/ 16950 UART (USB
Based) lets you connect an RS232 serial peripheral device such as a plotter, digital
signage device, receipt printer or bar code scanner to your notebook computer using
an available ExpressCard slot.
This USB-based ExpressCard supports data transfer rates up to 460 Kbps and eliminates
the need to upgrade serial peripherals to more modern interfaces (USB, etc.) for the
sake of compatibility, saving expense and hassle.
Packaging Contents
• 1 x ExpressCard Serial Adapter Card
• 1 x Driver CD
• 1 x Instruction Manual
System Requirements
• ExpressCard enabled computer system with available ExpressCard slot
• Microsoft® Windows® 2000/ XP/ Server 2003/ Vista/ Server 2008 R2/ 7 (32/64-bit), or
Apple® Mac OS® 8.x/ 9.x/ 10.x, or Linux® kernel 2.4.x/ 2.6.x
Instruction Manual
1
Page 5
Installation
Driver Installation
Windows 2000/ XP/ Server 2003/ Vista/ Server 2008 R2/ 7
1. Upon starting Windows, if the “Found New Hardware” wizard appears on the screen,
cancel/close the window and insert the included Driver CD into the computer’s CD/
DVD drive.
2. AutoPlay should automatically launch and display all of the folders on the CD
or provide a prompt to view all les on the CD. If not, open “My Computer” and
double-click on the CD/DVD drive.
3. Enter the folder “USB to Serial”, then “WIN_DRV” and double-click the Driver Installer
le.
4. This will launch the driver Installation wizard. Continue through the wizard and
once complete, all the necessary drivers will be installed.
5. Install the serial adapter card as outlined below and Windows will automatically
install the drivers. Once complete, the serial port should be ready for use.
Hardware Installation
After the drivers have been installed, the ExpressCard adapter will simply slide into the
ExpressCard slot on the computer system. Push the card all the way in, until it ‘clicks’
and locks into place. To eject the card, simply push the card further into the slot until it
clicks, and then release and it will then be automatically ejected from the slot.
NOTE: Some ExpressCard/54 slots do not rmly hold an ExpressCard/34 card so the
34mm to 54mm stabilizer bracket may be necessary (StarTech.com ID: ECBRACKET2).
Instruction Manual
2
Page 6
Specications
Host InterfaceUSB 2.0
Form FactorExpressCard/34 (34mm)
Chipset IDProlic PL2303
Connectors1 x 9-pin DB9 male
Serial ProtocolRS-232
Maximum Data Transfer Rate460.8 Kbps
Data Bits5, 6, 7, 8
ParityOdd, Even, Mark, Space, None
Stop Bits1, 1.5, 2
Buer Size512 byte
Operating Temperature0°C ~ 57°C (32°F ~ 135°F)
Storage Temperature-20°C ~ 80°C (-4°F ~ 176°F)
Humidity0% ~ 60% RH
Compatible Operating Systems
Windows 2000/ XP/ Server 2003/ Vista/
Server 2008 R2/ 7 (32/64-bit),
Mac OS 8.x/ 9.x/ 10.x, Linux 2.4.x/ 2.6.x
Instruction Manual
3
Page 7
Technical Support
StarTech.com’s lifetime technical support is an integral part of our commitment to
provide industry-leading solutions. If you ever need help with your product, visit
www.startech.com/support and access our comprehensive selection of online tools,
documentation, and downloads.
For the latest drivers/software, please visit www.startech.com/downloads
Warranty Information
This product is backed by a lifetime warranty.
In addition, StarTech.com warrants its products against defects in materials
and workmanship for the periods noted, following the initial date of purchase.
During this period, the products may be returned for repair, or replacement with
equivalent products at our discretion. The warranty covers parts and labor costs only.
StarTech.com does not warrant its products from defects or damages arising from
misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their
ocers, directors, employees or agents) for any damages (whether direct or indirect,
special, punitive, incidental, consequential, or otherwise), loss of prots, loss of business,
or any pecuniary loss, arising out of or related to the use of the product exceed the
actual price paid for the product. Some states do not allow the exclusion or limitation
of incidental or consequential damages. If such laws apply, the limitations or exclusions
contained in this statement may not apply to you.
Instruction Manual
4
Page 8
Hard-to-nd made easy. At StarTech.com, that isn’t a slogan. It’s a promise.
StarTech.com is your one-stop source for every connectivity part you need. From
the latest technology to legacy products — and all the parts that bridge the old and
new — we can help you nd the parts that connect your solutions.
We make it easy to locate the parts, and we quickly deliver them wherever they need
to go. Just talk to one of our tech advisors or visit our website. You’ll be connected to
the products you need in no time.
Visit www.startech.com for complete information on all StarTech.com products and
to access exclusive resources and time-saving tools.
StarTech.com is an ISO 9001 Registered manufacturer of connectivity and technology
parts. StarTech.com was founded in 1985 and has operations in the United States,
Canada, the United Kingdom and Taiwan servicing a worldwide market.
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.