DVI and Digital Audio to
HDMI Converter
DVI2HDMI
Instruction Manual
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.•
Increase the separation between the equipment and receiver.•
Connect the equipment into an outlet on a circuit different from that to which the receiver •
is connected.
Consult the dealer or an experienced radio/TV technician for help.•
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only and
do not represent an endorsement of a product or service by StarTech.com, or an endorsement of the product(s) to which this manual applies by the third-party company in
question. Regardless of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby acknowledges that all trademarks, registered trademarks,
service marks, and other protected names and/or symbols contained in this manual and
related documents are the property of their respective holders.
Instruction Manual
Instruction Manual
Table of Contents
Introduction .................................................................... 1
Package Contents ....................................................................... 1
Operating Controls & Functions .................................... 2
Specifications .................................................................. 3
Pin Configuration ............................................................ 4
Connection and Installation ........................................... 6
Technical Support ........................................................... 7
Warranty Information ...................................................... 7
i
Instruction Manual
Introduction
Thank you for purchasing a StarTech.com DVI2HDMI DVI and Digital
Audio to HDMI Converter. Offering convenient conversion of digital video
(DVI) and digital audio (digital coaxial) to HDMI, this device eliminates
cable clutter, while providing top quality digital content.
Features
Provides signal amplification and equalization for incoming TMDS data •
to ensure optimal signal quality
Supports resolutions up to 1920x1200 or 1080p input and output•
Supports two channel stereo, dolby digital 5.1, and DTS 5.1 sound •
input and output
Package Contents
1 x DVI to HDMI Converter•
1 x Instruction Manual•
1 x Power Adapter•
1
Instruction Manual
Operating Controls & Functions
DVI Input:1. Connects to the DVI output connector of your source
equipment.
Digital Audio (SPDIF) input:2. Connects to the digital audio output of
your source equipment.
HDMI Output:3. Connects to the HDMI input connector of your HDMI
Display or Switcher.
Power Input:4. Plug the supplied 5V DC Power Supply into the unit, the
LED will illuminate when the power is connected.
2
Specications
Digital Video Input
Digital Audio Input
HDMI Output
HDCP Version
Operation Frequency
Frequency Bandwidth
Input/Output
Resolutions
Instruction Manual
DVI-I Connector (DVI-D input signal only)
Coaxial (SPDIF)
19-pin HDMI Connector
HDCP 1.1, 1.0
Up to 165 Mhz
1.65Gbps (single-link)
PC
VGA@60/72/75/85Hz
SVGA@60/72/75/85Hz
XGA@60/70/75/85/87Hz
SXGA@60/75/85Hz
UXGA@60Hz, 1152@70/75/85Hz
HDTV
480p@60Hz
576@50Hz
720p@50/60Hz
1080i@50/60Hz
1080p@24/25/30/50/60Hz
Dimensions
DVI Compliance
HDCP Compliant
HDMI Compliant
Input Connectors
Output Connector
Bandwidth
Frequency
Power
105(W) x 76(D) x 30(H)mm
22 x 3 x 1.18”
DVI 1.0
HDCP 1.1
HDMI 1.2
1 x DVI-I (only supports DVI-D signal)
1 x Digital Coaxial RCA Female (supports two channel
stereo, dolby digital 5.1, and DTS 5.1)
1 x HDMI
1.65Gbps (single link)
165 MHz
5V 1A Center Positive
3
Instruction Manual
Pin Conguration
DVI-D Input Pin Assignment
DVI-Digital: Supports digital-only connections between the host computer
and display. This interface is designed for a 12 or 24-pin connection to
enable single or dual-link mode activation
Digital Only Connector Pin Assignments
Pin
Signal
Assignment
Pin
Signal
Assignment
Pin
Signal
Assignment
1
T.M.D.S Data 2-
2
T.M.D.S Data 2+
T.M.D.S Data 2
3
Shield
4
N.C.
5
N.C.
6
DDC Clock
7
DDC Data
8
N.C.
C1
N.C.
C4
N.C.
9
T.M.D.S Data 1-
10
T.M.D.S Data 1+
T.M.D.S Data 1
11
Shield
12
N.C.
13
N.C.
14
+5V Power
15
Ground (for +5V)
16
Hot Plug Detect
C2
N.C.
C5
N.C.
17
T.M.D.S Data 0-
18
T.M.D.S Data 0+
T.M.D.S Data 0
19
Shield
20
N.C.
21
N.C.
T.M.D.S Clock
22
Shield
23
T.M.D.S Clock+
24
T.M.D.S Clock-
C3
N.C.
4
Instruction Manual
HDMI Output Pin Assignment
Digital Only Connector Pin Assignments
Pin
Function
Assignment
Pin
Function
Assignment
1
T.M.D.S Data 2+
3
T.M.D.S Data 2-
5
T.M.D.S Data 1 Shield
7
T.M.D.S Data 0+
9
T.M.D.S Data 0-
11
T.M.D.S Clock Shield
13
CEC
15
SCL
17
DDC/CEC Ground
19
Hot Plug Detect
2
T.M.D.S Data 2 Shield
4
T.M.D.S Data 1+
6
T.M.D.S Data 1-
8
T.M.D.S Data 0 Shield
10
T.M.D.S Clock+
12
T.M.D.S Clock-
14
Reserved (N.C. on device)
16
SDA
18
+5V Power
5
Instruction Manual
Connection and Installation
The following images depict typical installation of the DVI2HDMI unit:
Straight Connection to Display
DVI2HDMI
1
1 - Source Device (e.g. DVD Player, Computer)
2 - DVI Cable (from source to DVI2HDMI DVI IN port)
3 - SPDIF Cable (from source to DVI2HDMI Digital Audio In port)
4 - HDMI Cable (from DVI2HDMI HDMI OUT port) to Display
5 - HDTV/Display
Connection Using an HDMI Switch
2
4
3
5
1 2
3
1 - Source Device (e.g. DVD Player, Computer)
2 - DVI Cable (from source to DVI2HDMI DVI IN port)
3 - SPDIF Cable (from source to DVI2HDMI Digital Audio In port)
4 - HDMI Cable (from DVI2HDMI HDMI OUT port) to Display
5 - HDTV/Display
6 - HDMI Cable
7 - HDTV/Display
4
6
6
5
7
Instruction Manual
Technical Support
StarTech.com’s lifetime technical support is an integral part of our commitment to provide industry-leading solutions. If you ever need help with your
product, visit www.startech.com/suppor t and access our comprehensive
selection of online tools, documentation, and downloads.
Warranty Information
This product is backed by a one year warranty.
In addition, StarTech.com warrants its products against defects in materials and workmanship for the periods noted, following the initial date of
purchase. During this period, the products may be returned for repair,
or replacement with equivalent products at our discretion. The warranty
covers parts and labor costs only. StarTech.com does not warrant its
products from defects or damages arising from misuse, abuse, alteration,
or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA
LLP (or their officers, directors, employees or agents) for any damages
(whether direct or indirect, special, punitive, incidental, consequential, or
otherwise), loss of profits, loss of business, or any pecuniary loss, arising
out of or related to the use of the product exceed the actual price paid
for the product. Some states do not allow the exclusion or limitation of
incidental or consequential damages. If such laws apply, the limitations or
exclusions contained in this statement may not apply to you.
7
StarTech.com has been making “hard-to-find easy” since 1985,
providing high quality solutions to a diverse IT and A/V customer
base that spans many channels, including government, education
and industrial facilities to name just a few. We offer an unmatched
selection of computer parts, cables, A/V products, KVM and Server Management solutions, serving a worldwide market through our
locations in the United States, Canada, the United Kingdom and
Taiwan.
Visit www.startech.com today for complete information about all
our products and to access exclusive interactive tools such as the
Cable Finder, Parts Finder and the KVM Reference Guide.
Loading...