USB 2.0 Multi-Card Reader/Writer
52535FCREADBK Instruction Manual
Actual product may vary from photo
5.25/3.5” Bay Black Multi Flash Card Reader
FFCCCC CCoommpplliiaannccee SSttaatteemmeenntt
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
UUssee ooff TTrraaddeemmaarrkkss,, RReeggiisstteerreedd TTrraaddeemmaarrkkss,, aanndd ootthheerr PPrrootteecctteedd NNaammeess aanndd SSyymmbboollss
This manual may make reference to trademarks, registered trademarks, and other protected names
and/or symbols of third-party companies not related in any way to StarTech.com. Where they occur
these references are for illustrative purposes only and do not represent an endorsement of a
product or service by StarTech.com, or an endorsement of the product(s) to which this manual
applies by the third-party company in question. Regardless of any direct acknowledgement
elsewhere in the body of this document, StarTech.com hereby acknowledges that all trademarks,
registered trademarks, service marks, and other protected names and/or symbols contained in this
manual and related documents are the property of their respective holders.
Instruction Manual
i
TTaabbllee ooff CCoonntteennttss
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
System Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Installing the Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Using Your Card Reader . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Inserting a Card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Removing a Card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Removing the Card Reader . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Windows Users . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Mac Users . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Technical Support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Warranty Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Instruction Manual
1
Thank you for purchasing a StarTech.com 3.5” bay Flash card reader. This panel fits into an open
3.5” . or 5.25” bay (using the supplied 5.25” bracket) and supports the most popular media cards,
including CompactFlash memory cards, IBM-Microdrives, SmartMedia memory cards, MS Pro
cards, Memory Stick cards, SecureDigital memory cards, and Multi-Media cards. The card reader
plugs into any USB port, making it easy to transfer files, images, and music between your computer
and your MP3 player, digital camera, cell phone, or PDA.
IInnttrroodduuccttiioonn
•
Powered by the USB bus, no external power source is needed
Features
System Requirements:
•
Windows 98SE (or higher) with a Pentium-class (or compatible) processor, or Mac
OS X with a Power PC (or above).
Package contents:
•
1 x Multi-card card reader/writer
This package should contain:
•
Supports drag and drop between cards
•
Reads and writes any files suited for PC or Mac computers
•
Fits into any 3.5” drive bay
•
Supports the following
media types:
Micro Drive
Smart Media Card
Secure Digital Card, Secure Digital High Capacity Card
Multi Media Card, Reduced Sized Multi Media Card
(adapter required)
Memory Stick, Memory Stick
(with memory select function)
Memory Stick
(Magic Gate/HS data transfer compatible)
Memory Stick
(Magic Gate/High Speed data transfer
compatible with memory select function)
Memory Stick Duo
(adapter required)
Memory Stick Duo
(Magic Gate/High Speed data transfer
compatible - adapter required)
Memory Stick Pro, Memory Stick Pro Duo
(Adapter required)
Magic Gate Memory Stick
Magic Gate Memory Stick Duo
(adapter required)
Memory Stick ROM
•
An open USB port
•
1 x Expansion slot mounting bracket
•
1 x Screw kit
•
1 x Beige Bezel
•
1 x Bracket for 3.5 Inch Floppy with Bezel
Instruction Manual
2
IInnssttaallllaattiioonn
This section will guide you through the installation of your card reader and the related software. Please
read through the instructions carefully and complete each step in the order listed. Depending on your
OS and the configuration of your system, the instructions below may not be identical to what you see
on your screen.
Note
: The instructions below outline how to install the card reader into a 3.5” drive bay.
Alternatively, you can use your card reader externally by plugging the USB cable into an open
USB port.
Note
: 35FCREADBK includes an optional beige bezel, that can be used in place of the
pre-installed black bezel, depending on the color of your computer case. To exchange the
bezel, use a slot-headed screw driver to release the plastic clips on the sides and bottom of
the unit (five in total), and align the beige bezel in its place. Ensure that the clips are secure
before proceeding.
1. Make sure that your system is unplugged and you are grounded.
2. Remove the cover of your system and remove the cover from a 3.5” drive bay (see your computer
user manual for details, if necessary).
3. Optional: Fasten the 5.25” bracket (provided) into an available 5.25” bay.
4. Gently insert the panel into the open 3.5” bay (after threading the attached USB cable into the
computer) until it is flush with the front of the case. Make sure the bracket is lined up with the
screwholes in the case, and screw the panel into place.
5. Thread the attached USB cable out the back of your computer and plug it into a USB port.You can
use the metal rear bracket cover to hold the cable in place. Just screw the bracket cover into an
open I/O bracket on the rear of your computer.
. Fasten the power connector (marked VCC1, USB1- , and USB1+) to the appropriate port on the
motherboard. Please note that this connection provides power to the card reader for the USB port
located on the front panel. As such, please note that the USB port will not function without
this connection being made.
6. Replace the computer case cover, and power on the computer.
7. Your computer will display a message saying new hardware has been found. Windows 98SE and
2000 users Follow the onscreen prompts and direct Windows to the appropriate folder on the
driver disk. Windows will install the necessary drivers.
Follow any on-screen prompts to complete the installation.
Installing the Panel
Instruction Manual
3
1. Turn on your computer.
2. Insert your memory card into the proper slot on the card reader.
3. Mac users: A new icon will appear on your desktop.
Windows users: A new icon will appear in “My Computer.”
4. The card can now be accessed as an extra disk.
Removing a Card
1. Make sure that none of the LEDs on the front of the card reader are flashing. If you remove the
card when the LEDs are flashing, data may be lost from your card.
2. Mac users should drag the memory card icon to the Trash bin.
Windows users should right-click on the drive icon and choose to eject the card.
3. Physically remove the card from the reader.
RReemmoovviinngg tthhee CCaarrdd RReeaaddeerr
Use this procedure to permanently uninstall the card reader.
1. Make sure there is no card reader connected to the USB port.
2. Click on the “Uninstaller” icon in the taskbar.
3. Click on “USB Storage Device - Change/Remove.”
4. Remove all installed components and click Next.
5. Choose to restart your computer and click Finish.
Windows Users
Mac users
1. If there is a memory card connected to the card reader, drag the memory card icon into the
Trash. Wait until the icon has disappeared.
2. Disconnect the card reader.
Inserting a Card
The LEDs on the card reader are your best indication of the reader’s activity.
• The solid Power LED indicates that the card reader is powered.
• A flashing R/W LED indicates that there is data being transferred to or from the card.
UUssiinngg YYoouurr CCaarrdd RReeaaddeerr
Instruction Manual
4
Standards USB 2.0
Data Transfer Rate Flash Cards: 700 Kbits/sec to 480 Mbps
Compatibility:
Micro Drive
Smart Media Card
Secure Digital Card
Secure Digital High Capacity Card
Multi Media Card
Reduced Sized Multi Media Card
(adapter required)
Memory Stick
Memory Stick
(with memory select function)
Memory Stick
(Magic Gate/HS data transfer compatible)
Memory Stick
(Magic Gate/High Speed data transfer
compatible with memory select function)
Memory Stick Duo
(adapter required)
Memory Stick Duo
(Magic Gate/High Speed data transfer
compatible - adapter required)
Memory Stick Pro
Memory Stick Pro Duo
(Adapter required)
Magic Gate Memory Stick
Magic Gate Memory Stick Duo
(adapter required)
Memory Stick ROM
LED Indicators Power, Activity
System
Requirements
An available 3.5” bay
98SE/2000/ME/XP/Vista or Mac OS X
Connections
1 x USB type ‘A’ female
1 x USB motherboard header connector
SSppeecciiffiiccaattiioonnss
Instruction Manual
5
6 November 2007 (Rev.B)
TTeecchhnniiccaall SSuuppppoorrtt
StarTech.com’s lifetime technical support is an integral part of our commitment to provide
industry-leading solutions. Visit www.startech.com/support, if you ever need help with your
product, and access our comprehensive selection of online tools, documentation, and
downloads.
WWaarrrraannttyy IInnffoorrmmaattiioonn
This product is backed by a one-year warranty. In addition, StarTech.com warrants its
products against defects in materials and workmanship for the periods noted, following the
initial date of purchase. During this period, the products may be returned for repair, or
replacement with equivalent products at our discretion. The warranty covers parts and
labor costs only. StarTech.com does not warrant its products from defects or damages
arising from misuse, abuse, alteration, or normal wear and tear.
LLiimmiittaattiioonn ooff LLiiaabbiilliittyy
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their
officers, directors, employees or agents) for any damages (whether direct or indirect,
special, punitive, incidental, consequential, or otherwise), loss of profits, loss of business,
or any pecuniary loss, arising out of or related to the use of the product exceed the
actual price paid for the product. Some states do not allow the exclusion or limitation of
incidental or consequential damages. If such laws apply, the limitations or exclusions
contained in this statement may not apply to you.
AAbboouutt SSttaarrTTeecchh..ccoomm
StarTech.com is “The Professionals’ Source for Hard-to-Find Computer Parts”.
Since 1985, we have been providing IT professionals with the quality products
they need to complete their solutions. We offer an unmatched selection of
computer parts, cables, server management solutions and A/V products and
serve a worldwide market through our locations in the United States, Canada, the
United Kingdom and Taiwan.
Visit www.startech.com for complete information about all our products and to
access exclusive interactive tools such as the Parts Finder and the KVM
Reference Guide. StarTech.com makes it easy to complete almost any IT
solution. Find out for yourself why our products lead the industry in performance,
support, and value.
Loading...