Startech USB110EXT2 User Manual

Instruction Manual

1 Port USB 1.1 Extender over Cat5/Cat6 - up to 131ft (40m)

USB110EXT2

DE: Bedienungsanleitung - de.startech.com
FR: Guide de l'utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
IT: Guida per l'uso - it.startech.com
NL: Gebruiksaanwijzing - nl.startech.com

PT: Guia do usuário - pt.startech.com

Local Extender

Packaging Contents

• 1x USB 1.1 Local Extender

• 1x USB 1.1 Remote Extender

• 1x Instruction Manual

System Requirements

• USB enabled host system with available USB port

• length of Category 5/5e/6 UTP cabling

• Microsoft® Windows® 2000/ XP(32/64 bit)/ Server 2003(32/64 bit)/

Vista(32/64 bit)/ 7(32/64 bit)/ Server 2008 R2/ 8 (32/64 bit)/
Windows CE 6.0, and Apple® Mac OS X®, and Linux®

Preparing Your Site

1. Determine where the local host system (i.e. computer) will be located.

2. Determine where the remote USB peripheral will be located.

3. If you are using surface cabling, ensure you have enough Cat5/6
unshielded twisted pair (UTP) cabling to connect the Local
Extender to the Remote Extender’s location, and that each end
is terminated with a RJ45 connector. The cabling should not go
through any networking equipment (i.e. router, switch). If the actual
devices are not set up yet, make sure to leave enough excess cable
slack to accommodate for changes in device placement.

OR

If you are using premise cabling, ensure that the Cat5/6 unshielded
twisted pair (UTP) cabling between the local Extender and the
Remote Extender has been properly terminated in a wall outlet/
panel in each location and there is a patch cable long enough
to connect the Remote Extender and the Local Extender to
their respective outlets. The cabling should not go through any
networking equipment (i.e. router, switch).

RJ45 connector

Remote Extender

USB type A female

connector

USB type A male

connector

RJ45 connector

For the most up-to-date information, please visit: www.startech.com

Manual Revision: 23/01/2013

Installation

UTP Cable (Up

to131ft/40m)

Local

Remote

1. Place the Local and Remote Extenders at the desired locations and
connect them together using the RJ45 terminated Cat5/6 cabling
prepared earlier (see “Preparing Your Site”).

2. Connect the Local Extender to the host computer system using the
built-in USB cable. The computer can be either powered On or

3. USB devices can now be connected to the Remote Extender
where they will then be detected by the host system.

Host Interface USB 1.1

Number of Ports 1

Connectors (Local)

Connectors

(Remote)

1x USB type A male

1x RJ45 female

1x USB type A female

1x RJ45 female

LEDs None

Compatible

Cabling

Category 5/5e/6/6a UTP cable

Max Distance 131ft (40m)

EDS Protection 8kV Contact, 16kV Air

Power Adapter USB Powered

Material Plastic

Operating

Temperature

Storage

Temperature

Operating

Humidity

Dimensions

(LxWxH)

Built-in Cable

Length (Local)

Built-in Cable

Length (Remote)

0°C~50°C (32°F~122°F)

-20°C~70°C (-4°F~158°F)

20~80% RH

85.0mm x 40.0mm x 25.0mm

18 in (45cm)

6 in (15cm)

Weight 1.8 oz (50g)

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit

• Consult the dealer or an experienced radio/TV technician for help.

from that to which the receiver is connected.

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols

This manual may make reference to trademarks, registered trademarks, and other protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only and do not represent an endorsement of a product or service by StarTech.com, or an endorsement of the product(s)
to which this manual applies by the third-party company in question. Regardless of any direct acknowledgement elsewhere in the body of this document, StarTech.com
trademarks, registered trademarks, service marks, and other protected names and/or symbols contained in this manual and related documents are the property of their respective holders.

hereby acknowledges that all

Technical Support

StarTech.com’s lifetime technical support is an integral part of our commitment to provide industry-leading solutions. If you ever need help with your product, visit www.startech.com/support and access
our comprehensive selection of online tools, documentation, and downloads.

For the latest drivers/software, please visit www.startech.com/downloads

Warranty Information

This product is backed by a three year warranty.
In addition, StarTech.com warrants its products against defects
for repair, or replacement with equivalent products at our discretion. The warranty covers parts and labor costs only. StarTech.com does not warrant its products from defects or damages arising from
misuse, abuse, alteration, or normal wear and tear.

in materials and workmanship for the periods noted, following the initial date of purchase. During this period, the products may be returned

Limitation of Liability

In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their directors, employees or agents) for any damages (whether direct or indirect, special, punitive, incidental,
consequential, or otherwise), loss of
the exclusion or limitation of incidental or consequential damages. If such laws apply, the limitations or exclusions contained in this statement may not apply to you.

loss of business, or any pecuniary loss, arising out of or related to the use of the product exceed the actual price paid for the product. Some states do not allow