Startech PEX2S952LP, PEX1S952LP, PEX2S952, PEX1S952 User Manual

Native PCI Express RS232 Serial Adapter Card with 16950 UART
PEX1S952 PEX2S952 PEX1S952LP PEX2S952LP
FCC Compliance Statement
Reorient or relocate the receiving antenna.•
Increase the separation between the equipment and receiver.•
Connect the equipment into an outlet on a circuit different from that to which the receiver •
is connected.
Consult the dealer or an experienced radio/TV technician for help.•
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other protected names and/or symbols of third-party companies not related in any way to StarTech.com. Where they occur these references are for illustrative purposes only and do not represent an endorsement of a product or service by StarTech.com, or an endorsement of the product(s) to which this manual applies by the third-party company in question. Regardless of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby acknowledges that all trademarks, registered trademarks, service marks, and other protected names and/or symbols contained in this manual and related documents are the property of their respective holders.
Instruction Manual
Instruction Manual
Table of Contents
Introduction .................................................................................... 1
Features ......................................................................................1
Package Contents .......................................................................1
Jumper Configuration ................................................................... 2
Hardware Installation .................................................................... 3
Driver Installation .......................................................................... 3
Windows 2000/XP Driver Installation ..........................................3
Windows Vista Driver Installation ................................................5
Specifications ................................................................................ 7
Technical Support ......................................................................... 8
Warranty Information .................................................................... 8
i
Instruction Manual
Introduction
Thank you for purchasing a StarTech.com PEX1S952/PEX2S952/ PEX1S952LP/PEX2S952LP Native PCI Express 16C950 UART Serial Card. This dual profile Serial card converts a PCI Express slot into one or two RS-232 (DB9) serial connections, while relying on a native, single­chip design for optimal performance and reliability.
Features
128-byte deep FIFO per transmitter and receiver •
Automated in-band software flow control using programmable Xon/Xoff •
in both directions
Automated out-of-band hardware flow control using Tx/Rx/RTS/CTS/ •
DSR/DTR/DCD/RI/GND
Compliant with IEEE1284, SPP/EPP/ECP parallel port •
Compliant with PCI Express base specifications revision 1.1 •
High Performance Dual Channel Oxford 950 UART •
Native single-Chip, single lane PCI Express •
Selectable power output on pin 9 for the serial port •
High speed RS-232 serial ports with data transfer rate up to •
460.8 Kbps
Package Contents
1 X Serial Card (Low Profile bracket preinstalled on LP models)•
1 X Driver CD •
1 X Instruction Manual •
1 X Low Profile Bracket (PEX1S952 only)•
2 X Low Profile Bracket (PEX2S952 only)•
1 x Full Profile Bracket (PEX1S952LP/PEX2S952LP only)•
1
Loading...
+ 8 hidden pages