Start cyli-SIZE LAB01 Quick Start Manual

LAB01

Manual Label Applicator

Dispenser

Core Holder (2)

Load Label Roll

Reel Guide (2)

ITEMS INCLUDED

1

1

2

HandleHex Wrench Thumbscrew (2)

A: Install handle onto feed roller
B. Install and tighten the thumb screws

A: Place bottle onto rollers and adjust screws
with hex wrench to position rollers until
bottle rests 1 - 2mm above strip plate
B: Tighten screws on both sides and remove
your bottle

3

4

Position Labels

B

A

C

A: Slide reel guide onto the hanger bar
B: Insert core holders into your label roll
and slide loaded roll onto reel hanger bar
C: Slide other reel guide onto the hanger bar

Adjust Height

B

SIDE VIEW

A

A

B

A: Position label roll for desired placement
and tighten thumb screws
B: Feed label liner under guide bar and brush

A

B

bottle

Set Up Dispenser

strip plate

advancement roller

LAB01_Quick_Start_Guide_b072208.Page 1 8/4/2008 2:50:09 PM

A

B

Continue Feeding Label Liner

START Labeling

LD5000

Set Label

Quick Start Guide

LAB01

4270 Airborn Dr, Addison, TX 75001, USA

972.248.1999 | [e-mail]

startinternational.com

Need more help? Download the full manual or contact us

6

5

Q8.8

cyli-SIZE

™

LABELER

BY START INTERNATIONAL

A: Turn handle until edge of label is 2mm
above strip plate
B: Position guide marker directly over the
gap between labels

B

A

A: Pass label liner under roller and over the strip plate
B: Pass label liner under advancement roller and over pressure roller

7

A: Place your bottle on the rollers and rotate
handle to apply label
B: Stop turning when guide marker is over
gap in next label

B

A

LAB01_Quick_Start_Guide_a072208.Page 1 8/4/2008 2:51:47 PM