Star Micronics SP500 Installation Manual

Attaching the SP500 vertical stand

1. Unpacking : Confirm that all accessories are included.

kit

3 × 12 screws (2)
(for attaching the paper holder)

2. Attachment procedures :

Note: Ensure that power that is supplied to the printer

and that all devices connected to the printer have
been switched OFF and that the power cord has
been unplugged before starting the modification.

2-1. Attaching the rubber foots

Attach the four rubber foots in the positions shown
in the figure 1.
Ensure that any soiling has been completely wiped
off before attaching the rubber foots.

Rubber foots (4)

Paper holder

fig.1 Attaching the rubber foots

2-2. Attaching the paper holder

1 Open the printer cover.
2 Attach the paper holder to the printer. Then tighten

the two M3 screws that were supplied to secure it
in place.

2-3. Setting the roll paper in place

Insert the roll paper as shown in the figure 3.

fig.2 Attaching the paper holder

fig.3 Setting the roll paper in place

80871300 VS-S500