Star Micronics SP349 Installation Manual

HOW TO ATTACH THE WALL METAL FITTINGS OF SP349

1. Unpacking :

Confirm that all accessories are
included.

Not supplied

φ

4mm screws(4)

Please prepare these

φ

4mm screws by yourself.

M3 screws(4)

Holder plates(2)

2. Attaching procedure :

Note1)Unplug the power plug from the outlet.
Note2)Select a position on the wall which is not

subjected to mechanical shocks or water
drops. Also confirm that the wall is
sufficiently wide for attaching the bracket.

2-1 How to attach the bracket

1 If attachment of the bracket on the wall is

not possible,first fix a wooden plate whose
size is more than 120mm×170mm×5mm.

2 Apply the bracket and mark the positions

of the screw holes.

3 Drill screw holes in the marked positions.
4 Firmly tighten and fix the bracket to the

wall with screws.

Bracket(1)

Wall material

Bracket

Attach and fix the bracket with the four

φ

4mm screws.
Please prepare screws of sufficient length
to sccure the bracket.

2-2 How to attach the holder plate

1 Remove the rubber foot.
2 Firmly tighten the two accessory screws

M3 in the direction shown in the figure to
attach the two holder plate onto the printer.
Tightening torque : 9kg fcm ± 1kg fcm

2-3 Setting

Slide the printer main unit downward from
the top of the bracket so that the holder
plate guides it to a secure position.

Rubber foot

Holder plate

80822265