Star Max STFFS45-3DF Owner's Manual

OWNER’S MANUAL

READ AND SAVE THESE INSTRUCTIONS

3 SPEED

18” STAND FAN

MODEL: STFFS45-3DF

145x210mm MRP5621-001 FS45-3D 说明书 365 20150307

Read Rules for Safe Operation and Instructions Carefully.

1. Do not leave the fan running unattended.

2. Keep electrical appliances out of reach from Children or infirm
persons. Do not let them use the appliances without supervision.

3. If the supply cord is damaged, it must be replaced by
manufacturer or its service agent or a similarly qualified person in
order to avoid a hazard.

4. This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved. Children shall
not play with the appliance. Cleaning and user maintenance shall
not be made by children without supervision.

5. When the fan was assembled, the rotor blade guard shall not be
taken off anymore

- Prior cleaning unplug the fan

- The rotor guard shall not be dissembled/opened to clean the
rotor blades

- wipe the fan enclosure and rotor blade guard with a slightly damp
cloth

1. Never insert fingers, pencils, or any other object through the grille
when fan is running.

2. Disconnect fan when moving from one location to another.

3. Be sure fan is on a stable surface when operating to avoid
overturning.

4. DO NOT use fan in window, rain may create electrical hazard.

5. Indoor use only.

6

CAUTION

WARNING

RULES FOR SAFE OPERATION

PART FIGURE

Height
adjustment ring

Base

“7” Finger screw

Fasten

Extension

pole

Internal Pole

Spinner

Loosen

Tighten

Tilt adjustment knob

Fan body

Back Guard

Circlip

Speed

Regulator

Motor

Oscillating Knob

Motor shaft

Blade

Plastic sleeve

Plastic Nut

Front Guard

1. Unscrew the “7” finger screw from the Extension Pole. (Fig.1)

2. Insert the extension pole in the chassis and tighten the “7” Finger screw. (Fig.2)

3. From the extension pole loosen the height adjustment ring and adjust the internal
pipe to the desired height. (Note: If you can’t find the internal pole, it slides inside
the extension pole. You can pull it out from the extension pole.) (Fig.3)

4. To attach the head unit to the extension pole, loosen the thumb screw on the
bottom of the head unit. Place the head unit on the extension pole and tighten the
thumb screw in alignment with the groove on the internal pole. (Fig.4)

CAUTION: Height adjustment ring must be fully fastened before the assembly of
the motor section to the extension pole.

ASSEMBLY OF CHASIS & COLUMN UNIT

Fig.1

Fig.2

Annular groove

Mounting hole

Thumb screw

Fig.3

Loo se

Fig.4

7