Star Manufacturing GR138TB, GR138TB 120V Installation Manual

Star
Manufacturing
International Inc.

10 Sunnen Dr.
St. Louis, MO 63143

Phone: [phone]
FAX: [phone]

2M-Z1500 Rev. D 2/8/01

TABLE TOP CLAM

SHELL TOASTER

TOSTADOR DE MESA

CONCHA DE ALMEJA

Installation and

Operating Instructions

Instrucciones

de instalación y

operación

Instructions

d’installation et

d’utilisation

TOASTER DE TABLE

À DEUX COQUES

Model# GR138TB 120V

Modelo GR138TB 120V

Modèle Nº GR138TB 120V

1

GENERAL INSTALLATION DATA

CAUTION

This equipment is designed and sold for
commercial use only by personnel trained and
experienced in its operation and is not sold for
consumer use in and around the home nor for
use directly by the general public in food service
locations.

INSTALLATION

1. Plug unit into dedicated 120V A.C. line with
20AMP receptacle.

2, DO NOT plug into 220V line. Doing so will

ruin the unit and void the warranty.

3. Each machine has been properly wired and
inspected at the factory for operation on the
voltage and type of current specified on the
nameplate.

CAUTION

OPERATING INSTRUCTIONS

Make sure unit is plugged into 20AMP receptacle
and is on a dedicated 120V A.C. line.

1. Turn unit on by placing switch in "ON"
position. The "Heat On" light, program
number and display will flash indicating unit is
heating. When the preset temperature is
reached, the heating light, display and program
light indicator will stop flashing followed by 3
beeps. (Initial startup heating time is
approximately 25 minutes).

2 Place product on the bottom cooking surface

of the unit and close the lid.

3. Press Start/Stop button and let displayed time
count down to "0" at which time unit will
beep. To turn off the beeper, press Start/Stop
button again.

4. Raise lid until it engages into first detent and
remove food. Using spatula, scrape residue
into rear grease catcher cup.
Note: Metal utensils may be used, however,
using nonmetal utensils will prolong the life of
the cooking surface.

5. Turn the unit off when not in use.

DO NOT CONNECT TO ANY OTHER
TYPE OF CURRENT OR THE MACHINE
WILL BE SERIOUSLY DAMAGED.

4. Level the unit using the adjustable feet in front
of the unit (approximately 1/2" adjustment).

5. Place grease catcher cup into support base
under rear spout.

6. DO NOT operate without top burn guard in
place.

INITIAL STARTUP

Before using the unit for the first time, clean and
heat for approximately 30 minutes.

DO NOT ADJUST TIME AND
TEMPERATURE

The unit time and temperature is preset by the
factory to the specific customer requirements for
flatbread and quesadillas. If adjustments are
required for additional food products, please refer
to the time or temperature programming section
in this manual.

TEMPERATURE/TIMER CONTROLLER
OPERATION SPECIFICATIONS

Startup:

1. The preset time will flash until preset
temperature is reached.

2. When the control reaches preset temperature,
time display, heat on indicator and program
indicator will stop flashing and the alarm will
beep three times.

2

Temperature:

1. To view the actual temperature, press and
hold "Temp Button". Display will read "Lo F" if
temperature is below 273°F and "Hi F" if
temperature is above 573°F.

MONTHLY LUBRICATION/INSPECTION

1. Apply two (2) drops of nontoxic mineral oil
onto counter balance shoulder screw and
nylon spacer.

2. Check all bolts/screws and tighten if necessary.

To Program Temperature:

1. Press and hold "Temp" (actual temperature
displays).

2. While holding "Temp", press "Start/Stop"
(program temperature displays).

3. Release "Temp" and "Start/Stop".

4. Press "5/+" or "6/-" to change current preset
program temperature.

5. Press "Start/Stop" to save the new
temperature.

6. Repeat procedure for other program (2, 3, 4,
5 & 6)

To Program Time:

1. Press and hold the program button (1 - 6) until
two beeps (preset time displays).

2. Release program button.

3. Press "5/+" or "6/-" to change time up or
down.

4. Press "Start/Stop" to save new time.

5. Repeat procedure for other programs.

CLEANING

All surfaces except the cooking grids are stainless
steel and can be cleaned with a warm, damp cloth
and detergent.

CAUTION

DO NOT IMMERSE OR LET THE UNIT
STAND IN WATER.

DO NOT HOSE DOWN.

KEEP AWAY FROM RUNNING WATER.

To remove burned on grease or food residue use
the following mixture:

1 Tablespoon liquid dish detergent
1 Cup of warm water

Programs (1 - 6):
To change program, press and hold desired
button (1 - 6) for one (1) second.

Timer:

1. To operate timer, press "Start/Stop" button.
Time will countdown to "0.00".

2. When timer reaches "0", alarm will sound.

3. Press "Start/Stop" to turn off the alarm.

CORD WITH 20 AMP PLUG

Two cord take-up brackets are located on the
bottom of the unit. These brackets are to be
used to wrap up the excess cord in the event that
the plug-in receptacle is located close to the unit.
These brackets will prevent accidental damage to
the power cord and prevent entanglement in the
working mechanism of the unit.

CAUTION

For models with #6 programmed for
"CLEAN" mode:

1. Press #6 button.

2. Open toaster to allow faster cooling.

3. Alarm will sound when toaster is 350° F.

4. Turn unit OFF.

5. Unplug the unit.

6. Begin toaster cleaning procedure using
answer system book 5, under toaster.

BEFORE CLEANING ALL OTHER UNITS
MAKE SURE POWER IS TURNED OFF
AND UNIT IS UNPLUGGED.

3