Star Manufacturing CG14SPTE Installation Manual

Star
Manufacturing
International Inc.

10 Sunnen Drive
St. Louis, MO 63143

Phone: [phone]
Fax: [phone]

2M-Z5890 Rev. D 11/18/09

Installation

and

Operating

Instructions

SPLIT LID TABLE TOP

TWO SIDED TOASTER

MODEL

CG14SPTE120V

CG14SPTE120C

ANSI/NSF 4

COOKING AND/OR HOT FOOD

STORAGE EQUIPMENT

9N47

120V = UL/US
120C = UL/US & CANADA

1

2

These symbols are intended to alert the user to the presence of
important operating and maintenance instructions in the manual
accompanying the appliance.

RETAIN THIS MANUAL FOR FUTURE REFERENCE

NOTICE

Using any part other than genuine Star factory supplied parts relieves the
manufacturer of all liability.

Star reserves the right to change specifi cations and product design without
notice. Such revisions do not entitle the buyer to corresponding changes,
improvements, additions or replacements for previously purchased
equipment.

Due to periodic changes in designs, methods, procedures, policies and
regulations, the specifi cations contained in this sheet are subject to change
without notice. While Star Manufacturing exercises good faith efforts to provide
information that is accurate, we are not responsible for errors or omissions
in information provided or conclusions reached as a result of using the
specifi cations. By using the information provided, the user assumes all risks in
connection with such use.

MAINTENANCE AND REPAIRS

Contact your local authorized service agent for service or required maintenance. Please record the model
number, serial number, voltage and purchase date in the area below and have it ready when you call to

ensure faster service.

SAFETY SYMBOL

Model No.

Serial No.

Voltage

Purchase Date

Business 8:00 am to 4:30 p.m. Central Standard Time
Hours:

Telephone: [phone] Local [phone]
Fax: [phone] Local [phone]

E-mail [e-mail]

[e-mail]
[e-mail]

Website: www.star-mfg.com

The Star Service Help Desk

Authorized Service Agent

Reference the listing provided with the unit

or

for an updated listing go to:

Website: www.star-mfg.com
E-mail [e-mail]
Telephone: [phone] Local [phone]

Mailing Address: Star Manufacturing International Inc.

10 Sunnen Drive
St. Louis, MO 63143
U.S.A

2

GENERAL INSTALLATION DATA

CAUTION

This equipment is designed and sold for commercial use only by personnel trained and experienced
in its operation and is not sold for consumer use in and around the home nor for use directly by

the general public in food service locations.
The unit time and temperature are preset by the factory to the customer requirements. If adjustments

are required, refer to the time or temperature programming sections in this manual.

INSTALLATION

1. Plug unit into dedicated 120V A.C. line with 20AMP receptacle.

2. DO NOT plug into 220V line. Doing so will damage the unit and void the warranty.

3. Each machine has been properly wired and inspected at the factory for operation on the

voltage and type of current specied on the nameplate.

4. DO NOT operate without top burn guard in place.

WARNING

DO NOT CONNECT TO ANY OTHER TYPE OF CURRENT OR THE MACHINE WILL BE
SERIOUSLY DAMAGED.

INITIAL START UP

Before using the unit for the rst time, clean and heat for approximately 45 minutes.

OPERATING INSTRUCTIONS

Make sure unit is plugged into 20AMP receptacle and is on a dedicated 120V A.C. line.

1. Turn unit on by placing switch in "ON" position. For approximately 3 seconds the current
grill setpoint temperature will display. After this time, the "Heat On" indicator will remain lit

and all four displays will ash indicating the unit is heating. When the preset temperature is
reached, the "Heat On" light will turn off, all four displays will stop ashing, and 3 beeps will

sound. Initial start-up heating time is approximately 30 minutes.

2. Open lid on side where product will be cooked. Place product on bottom cooking surface
of the unit and close the lid.

3. Press the "START/STOP" button for the same cooking area that the product is being cooked.
The display time will start to count down from the programmed time to "0:00." The countdown
may be stopped at any time by pressing and releasing the same "START/STOP" button.
The display will return to the programmed time.

4. When the countdown ends, the display will blink, read "0:00," and the alarm will beep every

second. To turn off the alarm, press the relative "START/STOP" button. The display will
return to the programmed time.

5. Raise lid until it engages into the rst stop position and remove food. Using spatula, scrape

residue into grease catcher cup.

Note: Metal utensils may be used, however, using nonmetal utensils will prolong the life of the
cooking surface.

6.

Turn the unit off when not in use.

Note: The right and left sides will operate independently of each other. All timers can be in
operation at the same time. The "0:00" display will show which cooking area is timed out.

3