Starkid 68070 User guide

UK

Operating instructions

Thanks

We thank for the acquisition of this device and want to serve with this information to prepare for you a
lot of joy at the operation.
Peruse in addition these tips please well and follow this also at the operation.
Lift this information please well and transmit this also to other users.

Age recommendation: from 14 years with introduction by experienced adults.

Scope of supply and description of the parts

1x helicopter
1x IR remote control
1x loading cable USB
1x screwdriver
1x rear rotor
1x operating instructions

Technology, security information, servicing and care, specific features to the batteries, battery
installation, accumulator loads.

Helicopter:

Their device is 3 canals of infrared-remote control helicopters with chargeable lithium polymer battery.

The lithium polymer battery with 3.7 V of tension and 75 mAh capacity is already inserted in the
helicopter. This is high-quality, but with false service also a dangerous tension memory.

Keep, therefore, please to these important information:

• Use to the store absolutely always only the provided remote control or a suitable loading cable
USB (included in delivery). Lithium polymer accumulators can be roused with Überladung!

• Lithium polymer accumulators are electric as well as against warmth sensitive: these
accumulators suffer from moisture, florid, deep-unloaded, to high streams, operation with too high
(greater 60 °C) or to low temperatures (smaller 0 °C).

• Pursue the helicopter possibly not with big cold, because the efficiency decreases.

• Avoid a deep unloading: long storage in unloaded state damages or destroys the cell.

• Charge, therefore, the batteries please at the latest all 6 months.

• For long time storage we recommend partial unloaded and the storage at a dry, chill place.

• Store only under constant supervision!

IR remote control:

Transmitter frequency: Infrared
Operation with 6 batteries 1.5 V LR6 / Mignon / FO Alkali-Mangan

Tips for the remote control-batteries:

Exchange of the remote control-batteries: Open the battery field lid of the remote control, perhaps you
must solve before the screw connection. Insert new alkali manganese batteries with the right Polarity
reversal (and-). Put on the battery field lid and screw together him.
Never load not rechargeable batteries.
Chargeable batteries m a y be loaded only by adults or under her sup erv is ion.
Never use unequal battery types or new and used batteries together.

UK

Take empty batteries from the remote control to avoid her running out, especially with
to longer use breaks.
Deliver spent batteries please at the known collective places.

Thus you load the lithium polymer accum u lator of the helicopter

Switch your helicopter with the Slide S witc hes (bottom) "OUT OF VISION". Switch on the remote
control (LED flashes red) and you connect the loading plug of the remote control (on the left) with the
loading socket of the helicopter (on the left).
Now the loading process begins. The LED (light-emitting diode) of the battery charger shines with the
store orange / green.
The loading duration can amount up to 30 minutes. Never load longer!
The necessary loading duration depends from of the rest capacity of the accumulator and, therefore,
can be shorter.
As soon as the light-emitting diode in the battery charger completely becomes red, the loading process
is finished.

Tips to the battery charger:

The helicopter accumulator may be loaded only with the provided battery charger or cable USB.
Pay attention please to the fact that children have no access to battery charger, remote control or
helicopter. These are no toys.
Importantly: examine please your battery battery charger regularly for sign of damages in cable, plug,
case and other parts. Use the battery charger with such a damage only again, as soon as the damage
was repaired competently.

Preparation to the operation

Charge the helicopter accumulator completely.
Lay new alkali manganese batteries in the remote control.
Switch the Slide Switches of the helicopter on "on". As a token of the operation readiness you see that
the LEDs in the helicopter shine.
Switch the remote control with the Slide Switches to "ON".
Now a red readiness announcement also flashes here.
Push the left big tax lever slowly completely upwards and then completely down.
Now the red LED shines permanently.
If you move the tax lever slowly once more upwards, the rotors of the helicopter begin to turn. This
process must be repeated, perhaps.

Now it goes off: Operation of your helicopte r, flight surroundings, trimming, start, taxes and
finishing the helicopter operation

Flight surroundings: Search for yourselves to the operation of the helicopter surroundings with

enough free surface on which neither the noise nor the dangerous rotor movement interferes. Are
aware of the danger of the rotary rotor sheets and provide for the fact that no children and animals, but
also no objects can be disturbed by the operation. Calculate on the fact that persons and objects could
be dripped by sudden breaking off of the helicopter from his flight path. They are responsible for the
fact that all threatened living beings and objects are far beyond the flying range and are warned by
you on time about the start. Hold yourselves sufficient distance of the helicopter in the operation, at
least 2 meters.