Sta-Rite MiniMax CH Installation Manual

Insulating the High Limits

when

REVERSING HEADS

on the

MINIMAX CH, NT & NT LOW NOx HEATERS

On the MiniMax CH, NT Standard and NT Low NOx heaters there is insulation
installed on the return head side of the heaters by the factory. This insulation is
there so that if the heads are reversed in the field, during initial installation of the
heater, the reflected heat from the flue collector will be insulated from the high
limits.

Return head in position before
removal. This view shows the
insulation installed by the
factory.

Return head removed and new
tube seals installed. Now ready
to accept the installation of
the main head.

Lift the installation to allow the
main head to be installed. When
head is placed into position,
release the insulation; it will
now shield the high limits from
the heat produced by the flue
collector.

Pentair Pool Products

1620 Hawkins Ave., Sanford, NC 27330 • [phone]
10951 West Los Angeles Ave., Moorpark, CA 93021 • [phone]

Rev. A 9-13-02 1 P/N 472258