Star Headlight & Lantern Phantom ULB28 User Manual

Lineum Star Split Phantom

Model ULB28

Model ULB28

Model ULB28Model ULB28

®

Dual Color Undercover Interior LED Lightbar

PLIT507 REV. B 2/19/16

IMPORTANT: Please read all of the following instructions before installing your new warning light.

Please Note: These instructions are provided as a general guideline only. Specific
mounting and/or wiring, may be necessary and are the sole responsibility of the
installer. Star Headlight & Lantern Co., Inc. assumes no responsibility for the
integrity of the installation for this or any of its products.

-1-

GASKET CURVED UP

Gasket Installation

1. Before installing any of the brackets, slide
the enclosed rubber channel over the
front edge of the baffle.

2. Install the gasket such that it curves
upward as pictured to the right.

Mounting

There are several optional mounting brackets that can be used to mount your

Phantom

™. Your light comes with the one that was selected at the time the light was
ordered. Please review the separate mounting instructions that are included, based upon
the mounting option that was selected.

274-ULB21-U1 Universal Mounting Kit

274-ULB21-CH 2006-2010 Dodge Charger
2005-2008 Dodge Magnum

274-ULB21-CH11 2011-2016 Dodge Charger

274-ULB21-CP 2011-2016 Chevrolet Caprice

274-ULB21-CV 2006-2011 Ford Crown Victoria
2009 Ford F150 and F250

274-ULB21-DU 2010-2015 Dodge Durango

274-ULB21-EX 2006-2016 Ford Explorer
2007-2013 Ford Expedition
2004-2015 Ford F150
2012-2016 Ford Interceptor SUV

274-ULB21-IM 2008-2013 Chevrolet Impala

274-ULB21-INT 2012-2016 Ford Interceptor (Taurus)

274-ULB10-RM 2009-2016 Dodge Ram

274-ULB21-TA 2007-2016 Chevy Tahoe
2007-2016 Chevy Yukon
2007-2016 Chevy Suburban

Split

Please Note: Every ULB28 comes with a standard baffle included. The 274-ULB21-CH

and 274-ULB21-CH11 kits also include a separate baffle that is specifically designed to
fit the Dodge Charger. It should be used in place of the standard baffle included.

The

Split Phantom

™

is designed to be mounted on the
inside of your vehicle. It is not intended for exterior
applications and is not warranted against water damage.

It is the sole responsibility of the owner to ensure the warning
light is secure. Check your light every time you enter the
vehicle to ensure that it is mounted securely. The manufacturer
assumes no responsibility for the secure mounting of this light.

-2-

Baffle Adjustment

1. After the light has been mounted (see separate mounting instructions), if adjustments
permit, slide the light forward until the top of it is touching the windshield.

2. Loosen the baffle screws and carefully slide the baffle forward until the gasket is forced
slightly downward by the pressure of the windshield.

3. Tighten the Baffle Adjusting Screws to secure the baffle in place .

CAUTION: Take extreme caution not to over tighten the screws!!! Over tightening

of the screws can strip the holes.

4. Once all of the brackets are securely tightened, check your mount to ensure the

desired angle is achieved. Stand in front of the vehicle and inspect the light through
the front windshield. The screws may be loosened slightly to allow for any final
adjustments necessary.

-3-