Star Headlight & Lantern Mini Phantom ULB9, Mini Phantom ULB9-1, Mini Phantom ULB9S-1, Mini Phantom ULB9S Installation And Instruction Manual

INSTALLATION AND INSTRUCTION MANUAL

Star

™

Mini Phantom

35-Pattern Undercover
Interior Mini LED Light

Models ULB9 and ULB9-1

(Discrete LEDs)

Models ULB9S and ULB9S-1

(Starburst LEDs)

PLITSTR46 REV. H 1/26/12

IMPORTANT: Please read all of the following instructions before installing your new light.

CAUTION: Please be sure to check that your cigarette plug outlet or hard wire is properly fused

Please Note: These instructions are provided as a general guideline only. Specific
mounting, wiring, and/or weather-sealing may be necessary and are the sole
responsibility of the installer. Signal Vehicle Products assumes no responsibility
for the integrity of the installation for this or any of its products.

with a 5 amp fuse. Testing the light before this fuse is properly installed will void
the warranty on the light.

This light is designed to be mounted on the inside of your vehicle.
It is not intended for exterior applications and is not warranted
against water damage.

It is the sole responsibility of the owner to ensure the warning light is
secure. Check your light every time you enter the vehicle to ensure that
it is mounted securely. The manufacturer assumes no responsibility for
the secure mounting of this light.

The

Mini Phantom

™ uses state-of-the-art Light Emitting Diode
(LED) technology. This warning light is comprised of ultra-high
intensity LEDs that are operated by a micro-controller to efficiently
produce light output with lifetimes up to 100,000 hours.

NOTICE

Due to continuous product improvements, we must reserve the right to change any specifications and information,
contained in this manual at any time without notice. Star Headlight & Lantern Co., Inc. makes no warranty of any
kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and fitness
for a particular purpose. Signal Vehicle Products, Inc. shall not be liable for errors contained herein or for
incidental or consequential damages in connection with the furnishing, performance, or use of this manual.

-i-

General

Typical mounting locations for the
vehicle, in the rear window, on the rear deck, or directed out the side window.

Mini Phantom

™ include the front windshield of a

While there is no specific “top” or “bottom” to the light, nor a specific “right” or “left” side, you
still must take into account which mount you will be using and which way the main bracket
should be mounted to the rear of the light, based on where you are going to mount the light
and where you will run the cord.

Parts

This package should contain the following:

1 ULB9, ULB9S, ULB9-1, or ULB9S-1 LED Light
1 274-ULB9BKT that includes the following:

1 ULB9-BKT Mounting Bracket set
1 274-ULB9MMC Mirror Mounting Clamp
2 DL15-CUP Suction Cups

ULB9-* or ULB9S-* [*=color(s)]

Cig Plug Version
(Includes 274-ULB9MMC, ULB9-BKT,
and (2) DL15-CUP)

ULB9-1-* or ULB9S-1-* [*=color(s)]

Hard Wired Version
(Includes 274-ULB9MMC, ULB9-BKT,
and (2) DL15-CUP)

RLKULB9-1-* or RLKULB9S-1-* [*=color(s)]

Kit containing:
(2) ULB9-1 Lights
(2) 274-ULB9BKT

274-ULB9MMC

(Includes clamp, bolt,
nut, and washer)

ULB9-BKT

(Includes four Philips head screws, two
flat washers, and two tooth washers)

DL15-CUP (qty=2)

-1-