Star Headlight & Lantern FM6907 User Manual

MODEL FM6907
IMPORTANT NOTE
ONE YEAR LIMITED WARRANTY
CHEVROLET CAPRICE
POLICE PACKAGE PLUG-IN
HEADLIGHT FLASHER
(2011+ Vehicles)
Congratulations! You are now the proud owner of the most technically advanced true 100% Solid State Selectable Pattern Headlight Flasher System in the market today. Add to it our never ending commitment to quality, when properly installed this new Flasher System will provide you with years of dependable trouble free service.
Operating Specifications:
10-16 VDC Input
Output: 9.5A per output
55 Watt Load on each output
High-Beam Override - Disables flasher when high-beams are activated
Less than 15mA standby current
Installation Instructions:
1. Using the bracket as a template, carefully mark and drill two 3/16” holes in the radiator support, taking caution as to not damage the radiator.
2. Position the Flasher as shown and install with two #8 bolts, washers, and nuts (not provided).
3. Carefully route the 2-wire and 6-wire Flasher
harness to the vehicle’s mating connector and connect them, making sure the harness will not interfere with the moving vehicle components and will not get damaged.
Flashing Headlight and Taillight Systems are intended for use on approved vehicles ONLY. It is the responsibility of the user of these systems to insure compliance to any Federal, State or Municipal regulations which may apply.
INSTALL ON THE RADIATOR
SUPPORT USING TWO USER
SUPPLIED #8 BOLTS, WASHERS,
AND NUTS OR 3/16” RIVETS.
Star Headlight & Lantern Co., Inc. warrants this flasher, under normal use, against factory defects in material and workmanship for one year after the date of purchase. The owner will be responsible for returning to the Service Center any defective item(s) with the transportation costs prepaid. The manufacturer will, without charge, repair or replace at its option, products, or part(s), which its inspection determines to be defective. Repaired or replacement item(s) will be returned to the purchaser with transportation costs prepaid from the service point. A copy of the purchaser's receipt must be returned with the defective item(s) in order to qualify for the warranty coverage.
This warranty shall not apply to any flasher which has been altered, such that in the manufacturer's judgment, the performance or reliability has been affected, or if any damage has resulted from abnormal use or service. This warranty does not apply to defect or damage occurring as a result of disaster, accident, abuse, misuse, li ghtning, power surges, or failure to follow instructions in any enclosed manuals. Any damage or defects occurring as a result of any unauthorized service or repairs by unauthorized persons shall be excluded from this warranty.
There are no warranties expressed or implied (including any warranty of merchantability or fitness), which extend this warranty period. The loss of use of the product, loss of time, inconvenience, commercial loss or consequential damages, including costs of any labor, are not covered. The manufacturer reserves the right to change the design of the product without assuming any obligation to modify any product previously manufactured.
This warranty gives you specific legal rights. You might also have additional rights which may vary from state to state. Some states do not allow limitations on how long an i mplied warranty lasts. Some states do not allow the exclusion or limitation of incidental or consequential damages. Therefore, the above limitation(s) or exclusion(s) may not apply to you.
PLIT255 REV - 1/13/12
Loading...