Star Headlight & Lantern DLX3-RRK, DLX4-RRK, DLX6-RRK Installation And Instruction Manual

INSTALLATION AND INSTRUCTION MANUAL

DLX3-RRK / DLX4-RRK / DLX6-RRK

LED Undercover Roof Rack Lighting Kit

The manufacturer warrants this LED light against factory defects in material and workmanship for five years

LED FIVE YEAR LIMITED WARRANTY

after the date of purchase. The owner will be responsible for returning to the Service Center any defective
item(s) with the transportation costs prepaid. The manufacturer will , without charge, repair or replace at its
option, products, or part(s), which its inspection determines to be defective. Repaired or replacement
item(s) will be returne d to the purchaser with transportation costs prepa id from the service point. A copy of
the purchaser's receipt must be returned with the defective item(s) in order to qualify for the warranty
coverage. Exclusions from this warranty include, but are not limited to, domes, and/or the finish. This
warranty shall not apply to any light, which has been altered, such that in the manufacturer's judgment, the
performance or reliability has been affected, or if any damage has resulted from abnormal use or service.

There are no warranties expressed or implied (including any warranty of merchantability or fitness), which
extend this warranty period. The loss of use of the product, loss of time, inconvenience, commercial loss or
consequential damages, including costs of any labor, are not covered. The manufacturer reserves the right
to change the design of the product without assuming any obligation to modify any product previously
manufactured.

This warranty gives you specific l egal rights. You might also have additional rights that may vary from state to
state. Some states do not all ow limitations on how long an implied warranty l asts. Some states do not allow
the exclusion or l imitation of incidental or consequential damages. Therefore, the above limitation(s) or
exclusion(s) may not apply to you.

PLIT478 REV. - 8/27/12

Due to continuous product improvements, we must reserve the right to change any specifications and
information, contained in this manual at any time without notice. Star Headlight & Lantern Co., Inc. makes no
warranty of any kind with regard to this manual, including, but not limited to, the implied warranties of
merchantability and fitness for a particular purpose. Star Headlight & Lantern Co., Inc. shall not be liable for
errors contained herein or for incidental or consequential da mages in connection with the furnishing,
performance, or use of this manual.

Installation Notes

Proper installation of the unit is essential for years of safe, reliable operation. Please read
all instructions before installing the unit. Failure to follow these instructions can cause
serious damage to the unit or vehicle and may void warranties.

• The installer must have a firm knowledge of basic electricity, vehicle electrical systems,
and emergency equipment.

• If you need to drill any holes when installing this light, please take care to check that
BOTH SIDES of your drilling surface are clear from obstructions, to ensure that you do
not damage your vehicle and or pre-existing wiring.

• Choose a mounting location away from any air bag deployment areas.

• Controls should be placed within convenient reach of the driver.

• Use only soap and water when cleaning this product. Use of other chemicals may

discolor the lens and/or housing, thus diminishing the output of the light. Lenses that
have become discolored should be replaced immediately!

• DO NOT use a pressure washer to clean this light. Use of a pressure washer may
damage the light and WILL VOID THE WARRANTY.

Before beginning the installation:

- Determine where the light is to be mounted.

- Check to see that there are no obstructions hindering the visibility of your light from the front,
rear, or side of the vehicle (wherever applicable).

- Determine where you will mount the switch.

- Verify that you have a clear path between the light and switch for your wires to run.

NOTICE

Please Note: These instructions are provided as a general guideline only. Some
vehicles may require special mounting, wiring, and/or weather-sealing. This is the
sole responsibility of the installer. Star Headlight & Lantern Co., Inc. assumes no

responsibility for the integrity of the installation for this or any of its products.

It is the sole responsibility of the installer to ensure the warning
light is secure. The manufacturer assumes no responsibility for
the secure mounting of this light.

-1-

Mounting

1. Determine how you wish to mount the
lights on the roof rack paying
particular attention to where you want
to run the harness to the switch (not
included).

2. Each undercover head should come
with two T-Bolts that will be used to
attach it to the roof rack.

4. Mount one of the brackets to the
rail of the roof rack by slightly
angling the T-bolts allowing them
to slip into the slot on the rail.

3. Install one T-bolt through each slot in the L­bracket as shown to the left. Loosely secure
the T-bolt with a flat washer, lock washer, and
a nut on each bolt. Repeat this for all of the
light heads.

5. Loosely hand tighten the nuts while slightly rotating each T-bolt
clockwise until it contacts the top and bottom of the groove,
helping secure it inside the groove. You may wish to use a
screwdriver or similar tool to help you rotate the T-bolts.

6. After all of the heads have been installed, make your final
adjustments positioning each head side-to-side and up and down
where you want them. Tighten all of the nuts, ensuring the T-bolts
remain rotated against the top and bottom of the roof rack channel.

7. The angle of each individual light can be adjusted by loosening the
bolt securing it. Make your adjustments then tighten the bolt.

-2-