Page 1
INSTALLATION AND INSTRUCTION MANUAL
SPBRK
SPBRK----23
SPBRKSPBRK
CYCLONE
CYCLONE
CYCLONECYCLONE
SPEAKER MOUNTING KIT FOR
SPEAKER MOUNTING KIT FOR
SPEAKER MOUNTING KIT FORSPEAKER MOUNTING KIT FOR
2008
2008----2009 FORD E350/450
20082008
2009 FORD E350/450
2009 FORD E350/4502009 FORD E350/450
23
2323
Please Note: These instructions are provided as a general guideline only.
Specific mounting, wiring, and/or weather-sealing may be necessary and are
the sole responsibility of the installer. The manufacturer assumes no
responsibility for the integrity of the installation for this or any of its products.
WARNING: ALWAYS WEAR HEARING PROTECTION PER OSHA 1910.95
PLIT427-23 REV. A 3/26/12
Page 2
SPBRK-23 Parts List
PART NUMBER
P30150-261P
P30056-15
P30076-2
P30056-22
P30076-1
P30096-4
P30069-64
FORD E350/450 BRACKET
1/4-20 X 1-1/4 HEX BOLT SS
1/4 SPLIT LOCK WASHER
1/4-20 X 1 HEX BOLT SS
1/4 FLAT WASHER SS
1/4-20 HEX NUT SS
THREAD LOCKING COMPOUND
DESCRIPTION
Installation
1. Mount speaker to bracket:
• Remove three (3) bolts from back of D-44 speaker. (SEE FIG.2)
• Apply thread locker to threads.
• Align holes in bracket to speaker and re-install bolts.
• Torque bolts to 30 in-lbs.
• Speaker wires must exit bottom of speaker (SEE FIG.1)
• Route wires through bracket exit holes.
2. Remove front grill:
• Follow manufactures instructions for remove and replace front grill.
• The speaker will be located between the headlight and the radiator, behind the grill.
(FIG.3)
• Remove 2 bolts on radiator support indicated on bracket (SEE FIG. 2)
• Use opposite holes for driver’s side installation.
3. Install Cyclone Speaker:
• Insert bracket with previously installed speaker.
• Use two existing bolts and hardware provided.
• Torque to minimum of 80 in-lbs.
4. Route wires:
• Route wires so they are not in contact with any sharp or abrasive surface.
• Fasten securely to nearby features.
• Refer to siren installation manual for wiring connections.
QTY.
1
3
3
2
2
2
1
-1-
Page 3
FIG.1
FIG.1
FIG.1FIG.1
IMPORTANT!
Speaker must be mounted with
drain hole/wiring exit facing down.
Failure to do so will void warranty!
FIG.3
FIG.3
FIG.3FIG.3
FIG.2
FIG.2
FIG.2FIG.2
USE EXISTING BOLTS IN THESE LOCATIONS
Optional Cyclone Speaker Brackets and Applications
MODEL # DESCRIPTION/APPLICATION
D-44
SPEAKER ONLY
UNIVERSAL "L" BRACKET
2004-2005 DODGE DURANGO
SPBRK-16
SPBRK-17 2003-2009 FORD CROWN VICTORIA (CENTER MOUNT)
SPBRK-18 2007-2009 CHEVROLET SUBURBAN / TAHOE
SPBRK-19 2006-2009 CHEVROLET IMPALA
SPBRK-20
SPBRK-21 TWO PIECE ADJUSTABLE BRACKET
SPBRK-22(L/R) 2008-2009 FORD F250 & F350
SPBRK-23 2008-2009 FORD F350 & F450
SPBRK-24 2007-2012 FORD EXPEDITION
SPBRK-27 2011-2012 DODGE CHARGER
SPBRK-28 2010-2012 FORD TAURUS
SPBRK-29 2011-2012 FORD F350
SPBRK-30 2011-2012 DODGE 4500
SPBRK-31 2011-2012 CHEVY CAPRICE
2001 FORD TAURUS
2002-2009 FORD EXPLORER
2004-2009 GMC ENVOY
2002-2009 CHEVROLET AVALANCHE
2004-2006 CHEVROLET SUBURBAN / TAHOE
2006-2009 DODGE CHARGER
2005-2008 DODGE MAGNUM
BRACKET PART #
NO BRACKET
P30150-237P
P30150-238P
P30150-239P
P30150-240P
P30150-241P
S30150-218, P30150-218AP
S30150-260(R/L)
P30150-261P
P30150-291P
P30150-302P
P30150-303P
P30150-318P
P30150-319P
P30150-324P
-2-
Page 4
WARNING: ALWAYS WEAR HEARING PROTECTION PER OSHA 1910.95
!!! WARNING !!!
Devices should be mounted only in locations listed in SAE standard J1849.
Assure clearances before drilling in vehicle.
Sound levels produced by speakers can cause permanent hearing loss.
Never operate this unit without adequate hearing protection for you and others
in the area. (OSHA 1910.95)
The manufacturer warrants each new product against factory defects in material and
ONE YEAR LIMITED WARRANTY
workmanship for one year after the date of purchase. The owner will be responsible for returning
to the Service Center any defective item(s) with the transportation costs prepaid. The
manufacturer will, without charge, repair or repl ace at its option, products, or part(s), which its
inspection determines to be defective. Repaired or replacement item(s) will be returned to the
purchaser with transportat ion costs prepaid from the service point. A copy of the purchaser's
receipt must be returned with the defective item(s) in order to qualify for the warranty coverage.
Exclusions from this warranty include, but are not limited to, bulbs, strobe tubes, domes, and/or the
finish. This warranty shall not apply to any light, which has been altered, such that in the
manufacturer's judgment, the performance or reliability has been affected, or if any damage has
resulted from abnormal use or service.
There are no warranties expressed or implied (including any warranty of merchantability or fitness),
which extend this warranty period. The loss of use of the product, loss of time, inconvenience,
commercial loss or consequential damages, including costs of any labor, are not covered. The
manufacturer reserves the right to change the design of the product without assuming any
obligation to modify any product previously manufactured.
This warranty gives you specific legal rights. You might also have additional rights that may vary
from state to state. Some states do not allow limitations on how long an implied warranty lasts.
Some states do not allow the exclusion or limitation of incidental or consequential damages.
Therefore, the above limitation(s) or exclusion(s) may not apply to you.
If you have any questions concerning this or any other product, please contact our
Customer Service Department at (585) 226-9025.
If a product must be returned for any reason, please contact our Customer Service
Department to obtain a Returned Materials Authorization number (RMA #) before you ship
the product back. Please write the RMA # clearly on the package near the mailing label.
Due to continuous product improvements, we must reserve the right to change any specifications and information,
contained in this manual at any time without notice. The manufacturer makes no warranty of any kind with regard
to this manual, including, but not limited to, the implied warranties of merchantability and fitness for a particular
purpose. The manufacturer shall not be liable for errors contained herein or for incidental or consequential
damages in connection with the furnishing, performance, or use of this manual.
NOTICE
-3-
Loading...