Star Headlight & Lantern 66 User Manual

CRS BACK-UP ALARMS
Lugs / No Wires
Cable
66L
/68L Series
Compact Reverse Speaker
66/68 Series w/Wires
66/68C Series w/Cable
66L/68L Series w/Lugs
Model # dB Current Voltage
Wires
66-087 87 0.3A 12-36VDC 66-097 97 0.3A 12-36VDC
66-097-12 97 0.3A 12VDC
Single Tone
66-102 102 0.3A 12-36VDC 66-107-12 107 0.7A 12VDC 66-107-24 107 0.3A 24VDC
68-112 112 0.7A 12-24VDC
Dual Tone
66-097DT 66-102DT 102 0.7A 12VDC
97
0.3A 12-36VDC
66-707A 77-107 0.3A 12-24VDC
Auto-Adjusting
66-802A 82-102 0.3A 12-24VDC 66-807A 87-107 0.7A
66-807A-24 87-107 0.3A
66-087SS 87 0.3A 12-36VDC
Star Spectrum
66-092SS 92 0.3A 12-36VDC 66-097SS 97 0.3A 12-36VDC
66L-087 87 0.3A 12-36VDC 66L-097 97 0.3A 12-36VDC
66L-097-12 97 0.3A 12VDC
Single Tone
66L-102 102 0.3A 12-36 VDC 66L-107-12 107 0.7A 12 VDC 66L-107-24 107 0.3A 24VDC
68L-112 112 0.7A 12-24VDC
Dual Tone
66L-097DT 97 0.3A 12-36VDC 66L-102DT 102 0.7A 12VDC
66L-707A 77-97 0.3A 12-24VDC
Auto-Adjusting
66L-802A 82-102 0.3A 12-24VDC 66L-807A 87-107 0.7A 12VDC
Single Tone /Night Silent
66-087NS 87 0.3A 12-36VDC 66-097NS 97 0.3A 12-36VDC 66-102NS 102 0.3A 12-36VDC
Dual Function 66-097DF 97 0.3A 12-36VDC
Selectable
Star Spectrum /Night Silent
66-802S 87 or 102 0.3A 12-36VDC
66-907S 97 or 107 0.7A 12VDC
66-087SSNS 87 0.3A 12-36VDC 66-097SSNS 97 0.3A 12-36VDC
Single Tone 68C-112 112 0.7A 24VDC
US Patent D639,688 S
PLIT444 REV. F 1/14/15
12VDC 24VDC
1. Mount the alarm in the rear of the vehicle with the sound opening outward towards the hazard zone.
2. For the models with wires, connect the black wire to the negative side of the battery or a good chassis ground. For the models with lugs, connect the bottom post (shown to the right) to the negative side of the battery or a good chassis ground.
3. For the models with wires, connect the red wire to an independent actuating switch or splice it into the back-up lights as shown in the diagram below. For the lug versions, connect the top post (shown above) to an independent actuating switch or splice it into the back-up lights. Please Note: The vehicles supply
voltage must be the same as the voltage rating specified on the alarm you are installing. Any other voltage applied will void the warranty.
4. For models with a 3-Wire Cable:
If you ordered a model with a selectable decibel level (66-802S or 66-907S), connect the white wire with the red wire (BAT +) for the lower dB output, or cut it short and tape it off for the higher dB output. An optional switch may be installed to allow the driver to select which level the back-up alarm operates at.
If you have a dual function model (66-097DF), the white wire is used for an alternate output. Connect it to the positive side of your power through the switch that controls the alternate function.
If you have a model with the Night Silent option (NS models), connect the white wire to your parking light wire, or other switched +12VDC source. The alarm will be de-activated whenever the white wire has +12VDC applied to it.
PRE-EXISTING SWITCH IN VEHICLE ALREADY CONNECTED TO REVERSE LIGHTS (OFTEN ACTIVATED BY THE GEAR SHIFTER)
BATTERY
The manufacturer warrants each new product, under normal use, against factory defects in material and workmanship for one year after the date of purchase. The owner wil l be responsibl e for returning to the Service Center any defective item(s) with the transportation costs prepaid. The manufacturer will, without charge, repair or replace at its option, products, or part(s), which its inspection determines to be defective. Repaired or replacement item(s) will be returned to the purchaser with transportati on costs prepaid from the service point. A copy of the purchaser's receipt must be returned with the defective item(s) in order to qualify for the warranty coverage. Exclusions from this warranty include, but are not limited to, bulbs, strobe tubes, domes, and/or the fini sh. This warranty shall not apply to any light, which has been altered, such that in the manufacturer's judgment, the performance or reliabili ty has been affected, or if any damage has resul ted from abnormal use or service. This warranty does not apply to defect or damage occurring as a result of disaster, accident, abuse, misuse, lightning, power surges, or failure to follow instructions in any enclosed manuals. Any damage or defects occurring as a result of any unauthorized service or repairs by unauthorized persons shall be excluded from this warranty. There are no warranties expressed or implied (including any warranty of merchantability or fitness), which extend this warranty period. The loss of use of the product, loss of time, inconvenience, commercial loss or consequential damages, including costs of any labor, are not covered. The manufacturer reserves the right to change the design of the product without assuming any obligation to modify any product previously manufactured. This warranty gives you specific legal rights. You might also have additional rights which may vary from state to state. Some states do not allow limitations on how long an implied warranty l asts. Some states do not allow the exclusion or limitation of incidental or consequential damages. Therefore, the above li mitation(s) or exclusion(s) may not apply to you.
SPLICE THE RED WIRE FROM THE BACK-UP ALARM INTO
THE WIRE WHICH SUPPLIES POWER TO YOUR REVERSE LIGHT
66-802S or 66-907S: OPTIONAL SWITCH FOR OUTPUT SELECTION:
CONNECT THE WHITE WIRE TO +12 VDC FOR LOWER db OUTPUT
66-097DF: OPTIONAL SWITCH FOR 2nd DEVICE TO ACTIVATE B-U A LARM:
CONNECT THE WHITE WIRE TO +12 VDC FOR ALTERNATE OUTPUT
NS Models: OPTIONAL SWITCH TO DE-ACTIVATE B-U ALARM AT NIGHT:
CONNECT THE WHITE WIRE TO PARKING LIGHTS OR +12 VDC SWITCH
or
or
WHITE
The White wire will only be present on models with a selectable
decibel level (66-802S and 66-907S), dual function capability
(66-097DF), or the Night Silent option (NS models).
GOOD CHASSIS GROUND
ONE YEAR LIMITED WARRANTY
RED
CHASSIS GROUND
BLACK
GOOD
GOOD CHASSIS GROUND
REVERSE
LIGHT
Loading...