Star Headlight & Lantern 63-000 User Manual

STARMATIC 63-000 BACK-UP ALARM

1. IMPORTANT: Please read all
of the following instructions
before installing your new Star
Back-Up alarm. This
instruction sheet applies only
for installation of the Star
model 63-000 on negative
ground vehicles only.

2. CAUTION: All of our DC
powered Back-Up Alarms are
polarity sensitive. All wires
connected to the positive
terminal of the battery should
be fused at the battery
rated load. Testing the alarm

before this fuse is properly
installed will void the
warranty on the alarm.

3. The Starmatic Self-Adjusting Back-up Alarm must be installed in the rear of the vehicle in a
location which will minimize the possibility of damage to the alarm due to collision or flying
objects.

4. The SOUND OPENING MUST FACE TO THE REAR with no obstructions that could reduce the
surrounding sound level heard by the alarm. Since this alarm is designed to concentrate its
sound output to the hazard zone only, it should be mounted approximately 4 FEET ABOVE

GROUND LEVEL.

5. The Starmatic must "hear" the surrounding sound level in order to adjust its output amplitude.
Mounting location can affect the Starmatic 63-000 automatic adjustment function. The installer
should insure the Starmatic is installed in a location which will maximize its output level. After
finding a good position for the alarm, fasten it in place with 5/16" nuts, bolts, and lock washers
(not supplied).

6. Connect the positive terminal on the alarm to the back-up lights or to an independent actuating
switch as shown in the diagram on the reverse side of this sheet. Please Note : The vehicles

supply voltage must be the same as the voltage rating specified on this alarm. Any other voltage
applied will void the warranty.

7. Connect the negative terminal on the alarm to the negative side of the battery or a good chassis
ground.

8. Use 14 AWG or 16 AWG wire for installation.

9. CAUTION: All Back-Up alarms should be TESTED DAILY before operation the vehicle. Alarms
should be listed on the daily maintenance report, and a record of the daily test should be recorded
in the vehicle maintenance file.

If you have any questions concerning this or any other Star product or need warranty service,

please contact our Customer Service Department at [phone].

for their

Wiring Diagram

ONE YEAR LIMITED WARRANTY

The manufacturer warrants each new product against factory defects in material and workmanship for one year after
the date of purchase. The owner will be responsible for returning to the Service Center any defective item(s) with the
transportation costs prepaid. The manufacturer will, without charge, repair or replace at its option, products which its
inspection determines to be defective. Repair or replacement item(s) will be returned to the purchaser with
transportation costs prepaid from the service point. A copy of the purchaser's receipt must be returned with the
defective item(s) in order to qualify for the warranty coverage. Exclusions from this warranty are FLASH
TUBES/BULB(S)as well as the finish. This warranty shall not apply to any product which has been altered, such
that in the manufacturer's judgment the performance or reliability has been affected or damage has resulted from
abnormal use or service.

There are no warranties expressed or implied (including any warranty of merchantibility or fitness), which extend this
warranty period. The loss of use of the product, loss of time, inconvenience, commercial loss or consequential
damages, including costs of any labor, are not covered. The manufacturer reserves the right to change the design of
the product without assuming any obligation to modify any product previously manufactured.

This warranty gives you specific legal rights. You might also have additional rights which may vary from state to
state. Some states do not allow limitations on how long an implied warranty lasts. Some states do not allow the
exclusion or limitation of incidental or consequential damages. Therefore, the above limitation(s) or exclusion(s)
may not apply to you.

If you have any questions concerning this or any other Star product,

please contact our Customer Service Department at [phone].

If a product must be returned for any reason, please contact our Customer Service Department to obtain a

Returned Goods Authorization number (RGA #) before you ship the product to Star.

Please write the RGA # clearly on the package near the mailing label.

PLITSTR34 REV. D 6/1/06