Star Headlight & Lantern 211R User Manual

MODEL 211R STROBE LIGHT INSTALLATION INSTRUCTIONS

WIRING DIAG

RAM

1. IMPORTANT: Please read all of the following instructions before installing your new
warning light

2. CAUTION: All of our DC powered warning lights are polarity sensitive. These lights
are polarity protected only if the appropriate fuse is used. All wires connected to the
positive terminal of the battery should be fused at the battery for their rated load.

Testing the light before this fuse is properly installed will void the warranty on
the light.

3. Your new warning light comes complete with two large washers, two small washers,
and two nuts.

4. Use the template provided on the back of this sheet. Place it in the exact position the
light is to be mounted. Mark three holes on the mounting surface. Take care to
ensure that the template does not move while you are marking each of the three
holes.

5. Remove the template and drill a 3/16" hole in the two outer locations only.
CAUTION: Take care not to drill through the headliner of the vehicle below.

6. For external wiring of your new strobe skip to Step 7. For internal wiring, proceed as
follows: Remove the headliner from the inside of the vehicle. Drill a 3/8" hole in the
center marked location. Place the light on the surface of the vehicle, routing the wires
through the hole. Align the two bolts from the light with the two holes you have
drilled. Place the large washer, then the small washer, and then the nut onto the bolt
and tighten until snug. Skip to Step 8.

7. Place the light on the mounting surface. Align the two bolts from the light with the two
holes you have drilled. Place the large washer, then the small washer, and then the
nut onto the bolt and tighten until snug.

8. The black wire is the ground lead and should be connected to a good chassis ground.

9. Connect the red wire to the positive side of the power through a single-pole, two
position switch and a 5 Amp fuse, checking the label on the warning light for proper
voltage.

ONE YEAR LIMITED WARRANTY

USING LIGHTED SWITCH

SP3860-1 SWITCH PANEL
(REAR VIEW)

ON

OFF

FUSE

5 AMP

+12 VDC

CONNECT TO

RED

BLACK

GOOD
CHASSIS
GROUND

There are no warranties expressed or implied (including any warranty of merchantibility or fitness),
which extend this warranty period. The loss of use of the product loss of time, inconvenience,
commercial loss or consequential damages, including costs of any labor, are not covered. The
manufacturer reserves the right to change the design of the product without assuming any obligation
to modify any product previously manufactured.

This warranty gives you specific legal rights. You might also have additional rights which may vary
from state to state. Some states do not allow limitations on how long an implied warranty lasts.
Some states do not allow the exclusion or limitation of incidental or consequential damages.
Therefore, the above limitation(s) or exclusion(s) may not apply to you.

To obtain warranty service or if you have any questions concerning this or any other Star product, please contact our

Customer Service Department at [phone]. If a product must be returned for any reason, please contact our

Customer Service Department to obtain a Returned Goods Authorization number (RGA #) before you ship the product to

Star. Please write the RGA # clearly on the package near the mailing label.

WARNING

LIGHT

RED

BLACK

GOOD
CHASSIS
GROUND

The manufacturer warrants each new strobe
light or revolving/flashing light against
factory defects in material and workmanship
for one year after the date of purchase. The
owner will be responsible for returning to the
Service Center any defective item(s) with the
transportation costs prepaid. The
manufacturer will, without charge, repair or
replace at its option, lights or light part(s)
which its inspection determines to be
defective. Repair or replacement item(s)
will be returned to the purchaser with
transportation costs prepaid from the service
point. A copy of the purchaser's receipt must
be returned with the defective item(s) in
order to qualify for the warranty coverage.
Exclusions from this warranty are FLASH
TUBES/BULB(S)as well as the finish. This
warranty shall not apply to any light which
has been altered, such that in the
manufacturer's judgment the performance or
reliability has been affected or damage has
resulted from abnormal use or service.

REV. G 2/26/03 PLITSTR40