Star Fans Start propeller User Manual

User ’s manual

STAR PROPELLER

STAR PROPELLER

User's manual

User ’s manual

WARNING : Read and follow these instructions carefully and be mindful of all warnings shown throughout.

STAR PROPELLER

KGS.

LBS.

Net weight

WARNING : TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURYS,
PLEASE OBSERVE THE FOLLOWING :

READ AND SAVE THESE INSTRUCTIONS

P1

1]. To ensure the success of the installation, be sure to read the instructions and review the diagrams
thoroughly before beginning.

2]. To avoid possible electric shock, be sure electricity is turned off at the main power box before wiring.
All electrical connections must be made in accordance with local codes, ordinances and/or the
National Electric Code. If you are unfamiliar with the methods of installing electrical wiring and
products, secure the services of a qualified and licensed electrician as well as someone who can
check the strength of the supportive ceiling members and make the proper installations and
connections.

3]. Make sure that your installation site will not allow rotating fan blades to come in contact with any
object. Blades should be at least 7 feet from the floor when the fan is in operation.

4]. If possible, mount ceiling fan on a ceiling joist - the joist must be able to support the motion and weight
of the moving fan. If the f an will be mounted on a cei li ng outlet box, make sur e it will support at leas t
50 lbs. The box and its supporting members must not be able to twist or work loose.
DO NOT USE PLASTIC BOXES. Installation on a concrete ceiling should be performed by qualified
personnel.

5]. Fan motor housing should be kept in carton until ready to be installed to protect its finish. If you are
installing more than one ceiling fan, make sure that you do not mix fan blade sets.

6]. After making electrical connections, spliced conductors should be turned upward and pushed
carefully up into outlet box. The wires should be spread apart with the grounded conductor and the
equipment - grounding conductor on one side of the outlet box and the " HOT " wires on the other side.

7]. Electrical diagrams with various different colors are for reference only. Make sure that the fan voltage
(120) is compatible with your own electrical system.

8]. After fan is completely installed, check to make sure that all connections are secure to prevent fan
from falling and/or causing damage or injury.

9]. The fan must be turned off and stopped before reversing fan direction.

10]. This fan is suitable for damp location.

"WARNING": "To Reduce The Risk Of Fire, Electric Shock, Or Personal Injury, Mount
To Outlet Box Marked Acceptable for Fan Support of 15.9 kg (35 lbs) or less And Use
Mounting Screws Provided With The Outlet Box."

www.starfans.co

Unpack and inspect fan carefully to be certain
all contents are included.

Flat Washer x3

Spring Washer x3

Machine Screw x2

Wood Screw x 3

For Mounting Bracket:

For Wire Connection:

Wire Nu t x 3

For Blade Installation:

Plastic Bushing x 7 (one spare bushing included)

Blade S crew x 7 (one spare screw included)

L type small screw driver (hexagon)

Hardware Bag

For Blade Balance :

Balanced slide x 1

Weight blo ck (3G x 5)

3 GM

3 GM

3 GM

3 GM

3 GM

Yoke cover
Assembly

Mounting Bracket

Canopy

Downrod

Fan assembly

Blade(3)

Deco Ring

Wall Control

Hardware Bag

Wood Screw x 2

Screw x 2

Wire Nu t x 2

P2

Unit pack / all in one box

(For Wood beam)

www.starfans.co