Star QCS-3-950HB Operators Manual

10 SUNNEN DRIVE P.O. BOX 430129 ST. LOUIS, MISSOURI 63143

[phone] y [phone] y FAX [phone]

GENERAL OPERATOR’S MANUAL

BLIMPIE CONVEYOR TOASTERS

MODEL QCS3-950HB

FOR SERVICE INFORMATION

U.S. AND CANADA CALL: 1-800-225-3958

24 HOURS/DAY 7 DAYS/WEEK

TABLE OF CONTENTS

UNCRATING AND INSPECTION PAGE 2
ASSEMBLY AND INSTALLATION PAGE 2
ROTARY POWER SAVER PAGE 3
SPRING LOADED FRONT BEARING PAGE 4
COOKING PROCEDURES PAGE 5
CLEANING PROCEDURES PAGE 5
TROUBLESHOOTING GUIDE PAGE 6, 7
MAINTENANCE PROCEDURES PAGE 7, 8
PARTS LIST PAGE 9
WIRING DIAGRAM PAGE 10

Conveyor Toasters & Ovens Cheese Melters Broilers Pretzel Bakers

2M-HG0652 Rev. A 7/22/04

Electric Cooking Equipment for the Food Service Industry

GENERAL OPERATOR’S MANUAL

BLIMPIE CONVEYOR TOASTERS

MODEL QCS3-950HB

PAGE 2

UNCRATING AND INSPECTION

Unpack the unit and components from the shipping container.
Remove all visible packing material and those from inside the cooking chamber.
If damage is discovered, file a claim immediately with the carrier that handled the shipment.

ASSEMBLY AND INSTALLATION

The QCS3-950HB was shipped fully assembled and ready to plug into a standard outlet specified for its
voltage and amp draw. Removal or replacement of the power cord and plug will

VOID the warranty. For

assistance contact the Holman Cooking Equipment Factory Service Team at 1-800-225-3958. Check Page
8 for the wiring diagram. Consult with a licensed electrician prior to installation.

FIGURE 1 – PLUG CONFIGURATION

NEMA 6-20 PLUG
208/240V / 20 AMPS

G

W

CAUTION

Allow enough space around the toaster for adequate ventilation.
Do not operate the unit without the crumb tray properly positioned. Overheating and poor toasting may occur.
Read all the labels on the outside of the unit and follow their instructions.

WARNING

DISCONNECT THE UNIT FROM THE POWER SOURCE BEFORE REMOVING OR INSTALLING ANY PARTS.

WARNING

Before installing unit(s), check with your local power company or your electrician to determine the actual
voltage coming into the equipment. For units rated 208 or 240 volts; never plug a 208-volt unit into 240 volts or
a 240-volt unit into 208 volts.

WARNING

Be absolutely sure that the ground connection for the receptacle is properly wired. Do not connect equipment
to power without proper ground connections. Improper grounding may result in personal injury or fatality.

GENERAL OPERATOR’S MANUAL

BLIMPIE CONVEYOR TOASTERS

MODEL QCS3-950HB

PAGE 3
OPERATION
Your BLIMPIE toaster is equipped with a Rotary Power Saver Switch, details are as follow:

STANDBY FULL HEAT

POWER/STANDBY

OFF

OFF

PATENTED

ROTARY POWER SAVER SWITCH

USING YOUR POWER SAVER

For toasters equipped with a Rotary Power Saver Switch, turn clockwise or counterclockwise to get in the
following positions:

FULL POWER

When in this position your equipment is at full power and ready to use.

OFF ROTARY
STANDBY

Two off positions are provided so that a single rotation to either direction will shut the unit off.
The standby position reduces the power consumption by 75%. Using this position during the

quiet times will save electricity, and keep the toaster warm. When needed, turn the switch to
FULL POWER. Recovery time is about 30 seconds.

GENERAL OPERATOR’S MANUAL

BLIMPIE CONVEYOR TOASTERS

MODEL QCS3-950HB

PAGE 4

SPRING LOADED FRONT BEARING ASSEMBLY

Your BLIMPIE Conveyor Toaster is equipped with a spring-loaded front bearing assembly as shown below in
(Figure 2). The spring-loaded bearing assembly keeps the conveyor belt at a constant tension as the unit heats
up and cools down. The conveyor belt is set to the proper tension when the white Teflon bushing is flush with
or 1/8’’ inside of the extension as shown in (Figure 3).

FIGURE 2

FIGURE 3