Star GR14SPTA-UK Installation Manual

SPLIT LID TABLE TOP

TWO SIDED GRILL

MODEL

GR14SPTA-UK

Installation and

Operation

Instructions

2M-Z7273 Rev. F 1/17/13

GR14SPTA

SAFETY SYMBOL

These symbols are intended to alert the user to the presence of important operating and maintenance instructions in the manual accompanying the appliance.

RETAIN THIS MANUAL FOR FUTURE REFERENCE

NOTICE

Using any part other than genuine Star factory supplied parts relieves the manufacturer of all liability.

Star reserves the right to change speciﬁ cations and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.

Due to periodic changes in designs, methods, procedures, policies and regulations, the speciﬁ cations contained in this sheet are subject to change without notice. While Star Manufacturing exercises good faith efforts to provide information that is accurate, we are not responsible for errors or omissions in information provided or conclusions reached as a result of using the speciﬁ cations. By using the information provided, the user assumes all risks in connection with such use.

MAINTENANCE AND REPAIRS

Contact your local dealer for service or required maintenance. Please record the model number, serial number, voltage and purchase date in the area below and have it ready when you call to ensure a faster

service.

Model No.

Serial No.

Voltage

Purchase Date

GENERAL INSTALLATION DATA

CAUTION

This equipment is designed and sold for commercial use only by personnel trained and experienced in its operation and is not sold for consumer use in and around the home nor for use directly by the general public in food service locations.

INSTALLATION

1. Plug the unit into a dedicated 230 VAC line with United Kingdom BS 1363A receptacle.

2. DO NOT plug into a 120V line. Doing so will damage the unit and void the warranty.

3. Each machine has been properly wired and inspected at the factory for operation on the voltage

and type of current specied on the nameplate.

4. IEC Plug & Cord are NOT included with this unit.

WARNING

DO NOT CONNECT TO ANY TYPE OF CURRENT OTHER THAN 230 VAC OR THE MACHINE WILL BE SERIOUSLY DAMAGED.

INITIAL START UP

Before using the unit for the rst time, clean and heat for approximately 45 minutes.

PRESET TIMES AND TEMPERATURES

If adjustments are required, please refer to the time or temperature programming section in this manual.

°F/°C CONVERSION

To change the temperature display from °F to °C or from °C to °F, hold the TEMP button while the unit is turned off. While holding the TEMP button, turn the unit on. The display will be the changed temperature mode. To change back, repeat the procedure.

OPERATING INSTRUCTIONS

1. Turn the unit on by placing the switch in the ON position. The HEAT ON indicator, program number and display will ash indicating the unit is heating. When the preset temperature is reached, the heating light, display and program light indicator will stop ashing followed by 3 beeps. (Initial

startup heating time is approximately 30 minutes).

2. Place product on the bottom cooking surface of the unit and close the lids.

3. Press the PROGRAM button and let the displayed time count down to "0" at which time the unit will beep. To turn off the beeper, press the PROGRAM button again.

4. Raise the lid until it engages into the rst detent and remove food. Using a spatula, scrape residue

into the grease catcher tray.

NOTE: Metal utensils may be used, however, using nonmetal utensils will prolong the life of the

cooking surface.

5. Turn the unit off when it is not in use.

TEMPERATURE/TIMER CONTROLLER OPERATION SPECIFICATIONS Startup:

1. The preset time will ash until the preset temperature is reached.

2. When the control reaches the preset temperature, time display, the HEAT ON indicator and program indicator will stop ashing and the alarm will beep three times.

Temperature:

1. To view the actual temperature, press and hold the TEMP button. The display will read "Lo" if the temperature is below 273°F (135°C) and "Hi" if the temperature is above 573°F (300°C).

+ 7 hidden pages