Star 301HLSMA Parts Manual

Star
Manufacturing
International Inc.

10 Sunnen Drive
St. Louis, MO 63143

Phone: [phone]
Fax: [phone]

DEEP FAT FRYER

MODEL 301HLSMA

Installation

and

Operating

Instructions

2M-Z1423 Rev. E 2/19/04

1

SAFETY SYMBOL

This symbol is intended to alert the user to the presence of important
operating and maintenance instructions in the manual accompanying
the appliance.

RETAIN THIS MANUAL FOR FUTURE REFERENCE

NOTICE

Using any part other than genuine Star factory supplied parts relieves
the manufacturer of all liability.

NOTICE

Star reserves the right to change specifications and product design
without notice. Such revisions do not entitle the buyer to corre­sponding changes, improvements, additions or replacements for
previously purchased equipment.

MAINTENANCE AND REPAIRS

Contact your local authorized service agent for service or required maintenance. Refer to the authorized service
center listing provided with the unit. The Star Service Help Desk (1-800-807-9054) is available during normal
business hours to answer any questions that may arise. Please have your model number and serial number for
faster service.

2

GENERAL INSTALLATION DATA

CAUTION

This equipment is designed and sold for commercial
use only by personnel trained and experienced in its
operation and is not sold for consumer use in and
around the home nor for use directly by the general
public in food service locations. For equipment to be
used by the general public, please contact the factory.

Proper connections and power supply are essential
for efficient performance. Connect six foot lead in
cord to a suitable grounded outlet of the correct
voltage. Be sure the switch is in the off position. The
receptacle should match the plug (NEMA configuration
of receptacle is: 6-30R). Four legs are provided and
should be installed for ease of cleaning. Level unit by
adjusting the (4) feet which have an adjustment of
1-3/8" (35 mm) for accurate leveling and perfect line­up with other units.

WARNING: Improper installation,
adjustment, alteration, service or maintenance
can cause property damage, injury or death.
Read the installation, operating and
maintenance instructions thoroughly before
installing or servicing the equipment.

This fryer is equipped for the voltage and wattage
indicated on the nameplate mounted on the underside
of the front edge. It is designed for use on alternating
current (AC) only. It is intended for use by properly
trained personnel only.

CAUTION

DO NOT CONNECT TO DIRECT CURRENT
(DC)

The installation of the appliance should conform to:

NATIONAL ELECTRIC CODE AND ALL
LOCAL ELECTRIC CODES AND
ORDINANCES AND THE LOCAL ELECTRIC
COMPANY RULES AND REGULATIONS

POWER SUPPLY

The Model 301HLSMA is wired at the factory for
operation on a single phase power supply 208/240V,
60 Hz.

CAUTION

DO NOT INSTALL WITHOUT FEET.

OPERATING INSTRUCTIONS

CLEAN KETTLE BEFORE USING

Take out baskets, push down and hold element catch,
located on left side of element housing. Lift up on
element lift handle until elements lock in a vertical
position, and remove kettle. The kettle can be cleaned
in a sink like any other pot or container.

ADDING FAT

Replace kettle and swing the element down by holding
element lift handle and pushing release catch down
and holding it there. Lower element. Fryer is now
ready for use. Add fat. A fat level line on the rear of
the kettle will guide you in determining the minimum
cold fat level. A higher fat level can be used when frying
bulky foods, such as chicken or fish cakes. The fat level
should be chosen carefully so that the foaming action
of the fat does not spill out of the kettle. If solid
shortening is used, pack carefully around the elements.

3