Stanton SPS5.2 User Handbook Manual
Notes
USER HANDBOOK
FOR
SPS5.2 TEMPERATURE CONTROLLER
Page SPS5.2 Manual12
RUN
HALT
STANTON
SET
SPS
5.2
Temperature Controller
Stanton Pottery Supplies Ltd.,
Canal Lane, Westport Lake,
Tunstall, STOKE-ON-TRENT,
Staffordshire, England.
ST6 4NZ
Tel: +44 (0)1782 835467
Fax: +44 (0)1782 812435
email: sales@stanton-kilns.co.uk
www.stanton-kilns.co.uk
SPS5.2 Manual Page
Issue: 5.2E01
Date: 10 July 98
© Stanton Pottery Supplies Ltd.
Manufactured in Staffordshire, U.K.
1
Table of Contents
5.0 Characteristics
1.0 Features
2.0 Operating Instructions
2.1 Power On 3
2.2 Instrument Capabilities 3
2.3 Programs 4
2.4 Keys 5
2.5 Setting 5
2.6 Firing Displays 6
2.7 Power Fail Recovery 7
3.0 Installation Instructions
3.1 Safety 7
3.2 Instrument Mounting 8
3.3 Internal Component Identification 8
3.4 Wiring 9
3
3
7
Electrical
Power supply
Voltage range: 216.2 - 253V
(Euronorm)
Frequency: 50Hz (nom)
Phases: 1
Power: Controller 3VA (max)
Switched output 75VA
Fuse: 1.0A anti-surge
Control Relay
Contact type: SPST NO
Switched Live nominal 230VAC output
@300mA max.
Thermocouple
Types: K,N,R & S
(User Selectable)
Connectors
Max. wire size 1.5mm²
Temperature
t2 setting
Trim Range: ±100ºC
Resolution: 1ºC
START DELAY setting
Range: 00:00 to 99hr 59min
Resolution: 1 min
Control Accuracy
P.I.D. Control
Reading accuracy: ±0.25% FSD ±1 digit
Environmental
Operating temperature range: 0 to +40°C
Storage temperature range: -10º to +55ºC
Enclosure sealing: IP65
Enclosure material: ABS or Polycarbonate
Enclosure colour: Light Grey RAL 7035
EMC (Electromagnetic Compatibility)
This instrument is designed for use mainly in
Domestic & Light Industrial environments
where electro-magnetic interference may cause
a loss of accuracy of the displayed temperature
reading of up to 3°C. Specified accuracy will
be restored when the interference is removed.
4.0 Error Displays
Thermocouple Failure 10
Heater Failure 10
Other Errors 10
5.0 Characteristics
Page SPS5.2 Manual2
10
11
The design of this instrument has been assessed
and tested assuming maximum connecting lead
lengths of 3.0 metres.
SPS5.2 Manual Page
11
Loading...