Stanley STDH7213 Original Instructions Manual

STDH7213

English Page 4

ENGLISH

2

(Original instructions)

B

A

0000 00-00

5

2

4

3

13

1

11

6

10

9

7

8

4

3

ENGLISH

(Original instructions)

C

D

12

E

6

7

Intended use

Your STANLEY impact drill has been designed for drilling in
wood, metal and concrete. This tool is intended for
consumer use only.

General Power tool Safety Warnings

Warning! Read all safety warnings and all
instructions. Failure to follow the warnings and

instructions may result in electric shock, fire

and/or serious injury.

Save all warnings and instructions for future reference.
The term "power tool" in all of the warnings listed below
refers to your mains operated (corded) power tool or battery
operated (cordless) power tool.

1. Work area safety

a. Keep work area clean and well lit. Cluttered or dark

areas invite accidents.

b. Do not operate power tools in explosive

atmospheres, such as in the presence of flammable

liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.

c. Keep children and bystanders away while operating

a power tool. Distractions can cause you to lose

control.

2. Electrical safety

a. Power tool plugs must match the outlet. Never

modify the plug in any way. Do not use any adapter
plugs with earthed (grounded) power tools.

Unmodified plugs and matching outlets will reduce risk of

electric shock.

b. Avoid body contact with earthed or grounded

surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric

shock if your body is earthed or grounded.

c. Do not expose power tools to rain or wet conditions.

Water entering a power tool will increase the risk of
electric shock.

d. Do not abuse the cord. Never use the cord for

carrying, pulling or unplugging the power tool. Keep
cord away from heat, oil, sharp edges or moving
parts. Damaged or entangled cords increase the risk of

electric shock.

e. When operating a power tool outdoors, use an

extension cord suitable for outdoor use. Use of a cord

suitable for outdoor use reduces the risk of electric
shock.

f. If operating a power tool in a damp location is

unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk of

electric shock.

3. Personal safety

a. Stay alert, watch what you are doing and use

common sense when operating a power tool. Do not
use a power tool while you are tired or under the

influence of drugs, alcohol or medication. A moment
of inattention while operating power tools may result in
serious personal injury.

b. Use personal protective equipment. Always wear eye

protection. Protective equipment such as dust mask,

non-skid safety shoes, hard hat, or hearing protection
used for appropriate conditions will reduce personal
injuries.

c. Prevent unintentional starting. Ensure the switch is

in the off-position before connecting to power
source and/or battery pack, picking up or carrying
the tool. Carrying power tools with your finger on the

switch or energising power tools that have the switch on
invites accidents.

d. Remove any adjusting key or wrench before turning

the power tool on. A wrench or a key left attached to a

rotating part of the power tool may result in personal
injury.

ENGLISH

4

(Original instructions)

Impact Drill STDH7213

Voltage V 220-240

Frequency Hz 50/60

Power input W 720

No-load speed /min 0-3000

Impact rate IPM 0-54000

Reverse/Forward rotation Yes

Chuck capacity mm 1.5-13

Max capacity

Concrete mm 16

Metal mm 13

Wood mm 32

Weight kg 2.5

Technical data