Page 1
NOTE: Your furniture may have different design features than those shown in the drawing.
97118-46 CREDENZA HUTCH
A-1260
CAREFULLY READ & UNDERSTAND ALL
5. CONNECT POWER:
INSTRUCTIONS BEFORE PROCEEDING!
LEVELING:
LEVEL
according to the Instructions
provided.
RECOMMENDED FOR ASSEMBLY!
the CREDENZA
CAUTION:
(2) OR MORE PERSONS
1. LIFT HUTCH ONTO CREDENZA:
Carefully lift the HUTCH onto the
CREDENZA and align it.
2. ATTACH HUTCH TO CREDENZA:
BACK SIDE
HUTCH
MENDING
PLATES
Plug POWER CORDS from
SWITCH into a standard
110V AC outlet ONLY.
Align Back of the HUTCH with Back of the
CREDENZA, center and secure with
MENDING PLATES and SCREWS, as
shown.
NOTE: If a Power Screwdriver is used,
use a "low torque" setting.
3. ADJUSTABLE SHELVES
To remove ADJUSTABLE SHELVES,
remove SCREWS from SHELF
SUPPORTS, then carefully lift
Shelves up and out of the HUTCH.
To reposition ADJUSTABLE
SHELVES, insert Stem of SHELF
SUPPORTS into Holes as shown.
Rest the SHELF on the SHELF
SUPPORTS, and reinstall SCREWS.
BACK SIDE
CREDENZA
110 Volt
AC Outlet
ONLY !
SCREW
4. REMOVABLE PARTITIONS
To install REMOVABLE PARTITIONS,
SCREWDRIVER
locate WIRE SUPPORTS in the Upper and
Lower Shelves. Align Grooves in the Top
and Bottom Edges of the PARTITIONS
SHELF SUPPORT
with the WIRE SUPPORTS, and carefully
slide the PARTITIONS between the Upper
and Lower WIRE SUPPORTS (as shown
below).
UPPER
SHELF
WIRE
SUPPORTS
LOWER
SHELF
REMOVABLE
PARTITION
GROOVE
Loading...