Stanley A-1258 97117-51 TV BOOKCASE DECK Assembly Instruction

NOTE: Your furniture may have different design features than those shown in the drawing.

A-1258

below).

and Lower WIRE SUPPORTS (as shown

slide the PARTITIONS between the Upper

Lower Shelves. Align Grooves in the Top

locate WIRE SUPPORTS in the Upper and

and Bottom Edges of the PARTITIONS

with the WIRE SUPPORTS, and carefully

To install REMOVABLE PARTITIONS,

REMOVABLE PARTITIONS

CAREFULLY READ AND UNDERSTAND ALL

INSTRUCTIONS BEFORE PROCEEDING!

SUPPORTS

LOWER

SHELF

WIRE

UPPER

SHELF

REMOVABLE

PARTITION

GROOVE

Note: If a Power Screwdriver is used, a

Rest the SHELF on the SHELF

SHELVES, insert Stem of SHELF

SUPPORTS into Holes as shown.

SCREWDRIVER

SUPPORTS, and reinstall SCREWS.

To reposition ADJUSTABLE

remove SCREWS from SHELF

up and out of the Armoire.

SUPPORTS, then carefully lift Shelves

To remove ADJUSTABLE SHELVES,

ADJUSTABLE SHELVES

"low torque" setting is recommended!

RECOMMENDED FOR ASSEMBLY!

(2) OR MORE PERSONS

CAUTION:

SCREW

SHELF

SUPPORT

NOTE: Your furniture may have different design features than those shown in the drawing.

A-1258-1

CAREFULLY READ AND

2

Self Adhesive

FELT DISCS

-51 T.V. BOOKCASE

-31 ENTERTAINMENT CONSOLE

INSTALLATION!

RECOMMENDED FOR

CAUTION: (2) PERSONS

ASSEMBLY and

1

UNDERSTAND ALL INSTRUCTIONS

Self Adhesive

FELT DISCS

24 7/8"

SCREWS

recommended.

NOTE: If a Power

Screwdriver is used, a

"low torque" setting is

BEFORE PROCEEDING!

UPRIGHTS

Attaching the PLASMA TV HUTCH to the ENTERTAINMENT CONSOLE

3

Plastic Back Panel Retaining Clips located at the four corners of the Center Back

Panel.

4. For access to TV Receiver wiring and ventilation, the Center Back Panel on

the -31 Entertainment Console may be removed, by loosening the screws on the

Secure the Plasma TV Mounting Panel to the Entertainment Console by

aligned with the Vertical Cleats on the back of the Plasma TV Mounting Panel.

fastening through the Uprights using Screws provided, as indicated in diagram

#3.

Plasma TV Hutch.

3. Lift the Plasma TV Hutch into position on top of the Entertainment Console,

and center it. The Uprights you attached to the Entertainment Console should be

bottom of the Entertainment Console Back Panel.

2. Once the uprights are securely fastened to the Entertainment Console, apply

four Round Self Adhesive Felt Discs [provided] to the Bottom Surface of the

1. Using Screws provided, attach the Wooden Uprights packed with the Plasma

mounted vertically, exactly 24 7/8" apart on center, and should be even with the

TV Hutch to the Back of the Entertainment Console. The uprights should be

4

Retaining Clips

Retaining Clips