Stanley A-1219 94611-136 236 DOUBLE PED Assembly Instruction
A-1219
PLATE TO THE LEGS
BRIDGE WITH THE LEGS.
(D) and Bolt (B). Tight with Open Wrench
as shown in Figure (3).
Mounting
Plate
attach with Flat Washer (E), Lock Washer
Upper
insert the three bolts of the legs through
the hole of the Upper Mounting Bridge and
Reverse the Pedestal as shown and
4. ATTACHING THE UPPER MOUNTING
and Nut (A) and tighten using open wrench . As
shown in Figure (2)
three Bolts pre – attached on the top of Legs
through. Put the Lock washer (D), Flat washer (E),
Attach the Lower Mounting Plate by inserting the
3. MOUNTING THE LOWER MOUNTING
Figure (1)
leg and screw (C) as shown. Make sure that
Stretcher and Legs are fitted tightly. As shown in
STRETCHER into the pre – drilled hole of the
Screw
2. CONNECTING THE LEGS AND STRETCHER:
surface such as a Carpeted Floor.
One by one insert dowel pin guide of the
TOP ASSEMBLY "upside down" on to a smooth
Dowel Pins
1. PREPARE FOR ASSEMBLY:
Two persons should assist each other in turning the
AND UNDERSTAND ALL INSTRUCTIONS
BEFORE PROCEEDING!
CAREFULLY READ
Stretcher
NOTE: Your furniture may have different design features than those shown in the drawing.
Pre-Drilled
Hole
D
B
E
A
D
(2) OR MORE PERSONS RECOMMENDED FOR
ASSEMBLY!
CAUTION:
E
Lower
Mounting
Plate
E
F
DCB
FLAT WASHER
LOCK WASHER
OPEN WRENCH
SCREW
NO
A
BOLT
NUT
PARTS LIST
5/16x 1 1/2
Lower
8 x 2
5/16
5/16
5/16
20
20
1
5/16
QTY
12
8
6
Mounting
Plate
E
D
A
Loading...