Stanley A-1211 93317-51 T Assembly Instruction
NOTE: Your furniture may have different design features than those shown in the drawing.
A-1211-1
2
Self Adhesive
FELT DISCS
-51 T.V. BOOKCASE
-30 ENTERTAINMENT CONSOLE
INSTALLATION!
RECOMMENDED FOR
CAUTION: (2) PERSONS
ASSEMBLY and
1
Self Adhesive
FELT DISCS
26 1/2"
SCREWS
recommended.
NOTE: If a Power
Screwdriver is used, a
"low torque" setting is
UPRIGHTS
Attaching the PLASMA TV HUTCH to the ENTERTAINMENT CONSOLE
3
Plastic Back Panel Retaining Clips located at the four corners of the Center Back
Panel.
6. Consult with the provider of your Plasma TV for instructions on mounting the
Television Set to the Plasma TV Hutch.
4.
turn the Retaining clips till they lock the Cover rail in place as shown in drawing
the opening of the Entertainment Console Deck. With the Cover Rail in place
5. Optional: To use the Cut-Out Cover Rail to fill the opening in the
clips turned down into
Entertainment Console Deck. Place the Cut-Out Cover Rail with the Retaining
4. For access to TV Receiver wiring and ventilation, the Center Back Panel on
the -30 Entertainment Console may be removed, by loosening the screws on the
Secure the Plasma TV Mounting Panel to the Entertainment Console by
aligned with the Vertical Cleats on the back of the Plasma TV Mounting Panel.
fastening through the Uprights using Screws provided, as indicated in diagram
#3.
Plasma TV Hutch.
3. Lift the Plasma TV Hutch into position on top of the Entertainment Console,
and center it. The Uprights you attached to the Entertainment Console should be
bottom of the Entertainment Console Back Panel.
2. Once the uprights are securely fastened to the Entertainment Console, apply
four Round Self Adhesive Felt Discs [provided] to the Bottom Surface of the
1. Using Screws provided, attach the Wooden Uprights packed with the Plasma
mounted vertically, exactly 26 1/2" apart on center, and should be even with the
TV Hutch to the Back of the Entertainment Console. The uprights should be
4
Retaining Clips
Retaining Clips
CAREFULLY READ
Note: If a Power Screwdriver is used, a
NOTE: Your furniture may have different design features than those shown in the drawing.
93317-51 T.V. Bookcase
A-1211
ALL INSTRUCTIONS
AND UNDERSTAND
PROCEEDING!
BEFORE
PARTITIONS with the WIRE
PARTITIONS between the Upper and
Lower WIRE SUPPORTS (as shown
below).
SUPPORTS, and carefully slide the
locate WIRE SUPPORTS in the Upper
and Lower Shelves. Align Grooves in the
Top and Bottom Edges of the
To install REMOVABLE PARTITIONS,
REMOVABLE PARTITIONS
"low torque" setting is recommended!
Holes as shown. Rest the SHELF on the
insert Stem of SHELF SUPPORTS into
SHELF SUPPORTS, and reinstall
SCREWS.
To reposition ADJUSTABLE SHELVES,
remove SCREWS from SHELF
SUPPORTS, then carefully lift Shelves up
and out of the Armoire.
To remove ADJUSTABLE SHELVES,
ADJUSTABLE SHELVES
SUPPORTS
LOWER
SHELF
WIRE
REMOVABLE
PARTITION
UPPER
SHELF
SCREWDRIVER
GROOVE
SCREW
SHELF SUPPORT
Loading...