Stanley 71211-38 Assembly Instruction

NOTE: Your furniture may have different design features than those shown in the drawing.

FLAT TIP

SCREW

DRIVER

A-1027

FILLER LEAVES should be kept in protective cloth bags (provided) and

stored FLAT when not in use. Remove FILLER LEAVES before moving

the TABLE.

4. FILLER STORAGE:

Support or until the FILLER is level with the TOP. If FILLER surface sits

above TOP surface, adjust METAL LEVELERS by bending upward slightly.

3. LEVEL FILLERS:

LEAF LEVELERS are located in each LEAF SUPPORT. Use a Flat Tip

Screwdriver to raise Leveler Screws approximately

raise LEVELLER SCREWS proximately

1

4

" while installing FILLERS.

FILLER LEAF should fit tightly against the edge of the TABLE TOP. As each FILLER

LEAF is installed, secure it to the other FILLER LEAVES by locking the SASH LOCK.

All FILLER LEAVES should be locked in place as they are installed. For best results,

LEAF positioned next to it. (SEE DIAGRAM)

Each FILLER LEAF should rest on two LEAF SUPPORTS. The inside edge of the

The number on each LEAF should be aligned with the corresponding number on the

FILLER LEAVES should be positioned on the TABLE. Install the FILLER LEAVES in

sequence, beginning with Leaf "1-2", then "2-3", and so on.

2. INSTALL FILLERS:

The underside of each FILLER LEAF is marked with numbers, to indicate how the

SUPPORTS

LEAF

AND UNDERSTAND ALL

BEFORE PROCEEDING!

CAREFULLY READ

INSTRUCTIONS

(3) OR MORE PERSONS

RECOMMENDED FOR

ASSEMBLY!

CAUTION:

1

4

" above surface of Leaf

LEVELER

SCREWS

FLAT TIP

DRIVER

SCREW

3

3

SUPPORTS.

2

1. PREPARE FOR ASSEMBLY:

Move all Chairs away from the

TABLE, and extend all LEAF

LEAVES

FILLER

CATCH

LOCK

SASH

2

FILLER LEAF

LEVELER

METAL

4

4

1

1