Standard Pump SP-430EX, SP-440EX Operations & Parts Manual

Operation & Parts Manual

Models: SP-430EX & SP-440EX

OIPM-EXP-0818

Introduction

This manual pertains to the SP-430EX & SP-440EX Series drum pump motors. When properly installed
and operated, your Standard Pump motor and pump will provide long, trouble-free service; therefore,
please read this manual carefully before carrying out any operations on the pump-motor unit. Any use
other than that described herein is considered incorrect and; consequently, Standard Pump, Inc. shall not
be held responsible for any damages to people or property. In case of doubt or inquiries, please apply to
our Technical Service department directly at the following address:

Standard Pump, Inc.

1610 Satellite Blvd, Suite D

Duluth, GA 30097 U.S.A.

Tel. [phone]
Fax [phone]

www.standardpump.com

[e-mail]

Index

Introduction.........................................................................................................................2

Safety..................................................................................................................................3

Installation...........................................................................................................................4

Operation & Specifications..................................................................................................5

Declarations........................................................................................................................7

General Terms &

Conditions, Warranty..............................................................................8

2

OIPM-EXP-0818

SAFETY

1. Introduction
This manual contains all the information needed for the correct installation, use and maintenance of your new
Standard Pump, Inc. motor. It should be read and understood by all the personnel involved in installation,
operating and servicing of the pump before it is started.

2. Operator Qualification and Training
The personnel in charge of the installation, operation and maintenance of the pump unit we produce must be
qualified and able to perform the operations described in this manual. Standard Pump, Inc. shall not be held
responsible for the training level of personnel and for the fact that they are not fully aware of the contents of this
manual.

3. Safety Instructions

FOR YOUR OWN SAFETY:
BEFORE UNDERTAKING ANY SERVICE OPERATION ON YOUR MOTOR OR PUMP, PLEASE MAKE
SURE TO WEAR THE PROPER PROTECTIVE GEAR.

GENERAL DANGER
NEVER use a plastic pump or an open, splash-proof, TEFC or
flammable or combustible material. ALWAYS use and store the pump and motor in an upright position.

DANGER: POWER SUPPLY
NEVER perform any maintenance operation on the motor while it is running or before it has been disconnected
from the power supply. Avoid any possible hazard that might be caused by electric power. ALWAYS check the
electrical specifications on the motor data plate and make sure they correspond to the power supply to which it
will be connected.

non-ATEX motor when pumping or mixing

ALWAYS place motor in the OFF position prior to connecting the power source. NEVER immerse the
motor in liquid.

ALWAYS use an ATEX Zone 1 approved plug and receptacle for ATEX motor models.
ALWAYS use a UL/CSA Class I Division 1 Group D approved plug and receptacle for Hazardous Location

motor models.

NEVER operate ATEX rated or Haz Loc rated motors outside their rated ambient temperature range of -20°C
to +40°C.
Warning: Explosion Hazard - Do not replace the cord on Explosion proof motor models. Replacing the cord will
invalidate the safety of the equipment. Return the motor back to the manufacturer for cord replacement. Do
not open or repair the flame-proof joints of Explosion proof motors. Contact the manufacturer for cord, fuse,
and circuit board replacement.
Static sparking can cause an explosion. Always follow NFPA 77 and CLC/TR 60079-32-1 guideli
control of static electricity and proper grounding methods when using ATEX and Hazardous Location motor
models. When operating in a hazardous area or pumping a hazardous fluid, the motor and entire pump system
must be grounded to prevent static discharge using appropriate grounding wires and connectors.

4. Noise Level
At normal operating conditions, SP-430EX and SP-440EX motors produce a sound level equal or less than 81
dBA

at a distance of three feet (~ one meter).

nes for

5. Modifications and Spare Parts
Any changes concerning the service of the motor as originally purchased, can be executed only after written
approval from
and approved accessories. The use of non-original spare parts
and removes any responsibility on our behalf for any damage caused to people or th

Standard Pump, Inc. It is recommended to use only genuine Standard Pump, Inc.

spare parts

or non-approved accessories will void warranty

ings.

3

OIPM-EXP-0818