Stairville MATRIXX FX-440 DMX Owner's Manual

Owner‘s Manual

LED MATRIX
FLOWER EFFECT

MATRIXX FX-440 DMX

2

Congratulations on your purchase of this LED Effect Light.
To get the most from your equipment you must read all of this manual

before using it rst time.

Table of Contents

1. Safety Instruction .......................................................................... 3

2. Technical Specification ................................................................... 4

3. How To Setup The Unit ................................................................5

3.1 Control Panel .........................................................................5

3.2 Main Function ......................................................................6

4. How To Control The Fixture .......................................................... 9

4.1 Master/Slave pre-prog. Function ............................................9

4.2. Easy Controller (by CA-8) ...................................................... 9

4.3 DMX Controller ....................................................................10

5. DMX 512 Configuration .............................................................. 10

6. DMX512 Connection ................................................................. 11

7. Troubleshooting ..........................................................................12

8. Fixture Cleaning .......................................................................... 13

9. Disposal ...................................................................................... 13

3

1. Safety Instruction

You have to carefully read the instruction, which includes impor­tant information about the installation, usage and maintenance.

• Please keep this User Guide for future consultation. If you sell the unit
to another user, be sure that he also receives this instruction booklet.

• Unpack and check carefully there is no transportation damage before
using the unit.

• Before operating, ensure that the voltage and frequency of power sup­ply match the power requirements of the unit as stated in this manual.

• It’s important to ground the yellow/green conductor to earth in order to
avoid electric shock.

• The unit is for indoor use only. Use it only in a dry location. Exposing the
device to rain or moisture would cause the risk of electrical shock or re.

• The unit must be installed in a location with adequate ventilation, at

least 50 cm from adjacent surfaces. Be sure that no ventilation slots are
blocked.

• Disconnect the device from the mains power before any servicing or
maintenance.

• Maximum ambient temperature is TA: 40°C. Don’t operate it where the
temperature is higher than this.

• In the event of serious operating problem, stop using the unit imme­diately. Never try to repair the unit by yourself. Repairs carried out by
unskilled people can lead to damage or malfunction. Please contact the
nearest authorized technical assistance centre. Always use the same
type spare parts.

• Do not connect the device to any dimmer pack.

• Do not look directly at the LED light beam while the xture is on.

• There are no user serviceable parts inside the xture. Do not open the
housing or attempt any repairs by yourself. If the xture shows any vis­ible damage or in the unlikely event, that your xture may require serv-

ice, please contact your nearest dealer.

• Due to the magnifying type lens, please keep the lens out of contact
with direct sunlight. Direct sunlight can cause heat to build up inside of
the unit, which will seriously damage the device.

• Don’t connect more that 20 units to one AC mains power supply lead.
Otherwise it could be overloaded and break down.

4

2. Technical Specification

• Featuring 144 high brightness, each controllable LEDs, the Matrix LED
delivers fabulous text patterns, geometric gures, dynamic scanning,

rolling, rotating and zooming effects.

• Great built-in lighting shows under Master/Slave operation triggered by
music.

• Optional CA-8 easy controller for enjoying instant lighting shows at you
ngertips.

• LED display for easy navigation.

• Input Voltage: 100V~240V 50/60Hz

• Power consumption: 15W

• LED: Total 144pcs,

• Red 36pcs, Green 36pcs, Blue 36pcs, White 36pcs

• Dimension: 280 x 192 x 243mm

• Weight: 2.9 kg

5

3. How To Setup The Unit

3.1 Control Panel

q Display: To show the various menus and the selected functions

LED

w DMX

On DMX input present

e MASTER

On Master Mode

r SLAVE

On Slave Mode

t SOUND

Flashing Sound activation

Button

y MENU

To select the programming functions

u DOWN

To go backward in the selected functions

i UP

To go forward in the selected functions

o ENTER

To conrm the selected functions

a Sensitivity: Adjust sensitivity of the sound control.
s Microphone: Receive music for the sound active.
d Only for remote control: By connect to the 1/4” microphone jack to

control the unit for Stand by, Function and Mode function.