Stahls Hotronix The MAXX Press Operator's Manual
16Ǝx20Ǝ
15Ǝx15Ǝ
11Ǝx15Ǝ
D I G I T A L C L A M
The MAXX
™
Press
OPERATOR’S MANUAL
S E R V I C E H O T L I N E : 8 0 0 . 7 2 7 . 8 5 2 0
Read all instructions.
Use heat press only for its intended use.
To reduce the risk of electric shock, do not immerse the heat press in water or other liquids.
Never pull cord to disconnect from outlet, instead grasp plug and pull to disconnect.
Do not allow cord to touch hot surfaces, allow heat press to cool completely before storing.
Do not operate heat press with a damaged cord or if the equipment has been dropped or damaged.
To reduce the risk of electric shock, do not disassemble or attempt to repair the heat press. Take it
to a qualified service person for examination and repair. Incorrect assembly or repair could increase
the risk of fire, electric shock, or injury to persons when the equipment is used.
This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
Close supervision is necessary for any heat press being used by or near children. Do not leave equipment unattended while connected.
Burns can occur when touching hot metal parts.
To reduce the likelihood of circuit overload, do not operate other high voltage equipment on the same
circuit.
If an extension cord is necessary, then a 20 amperage rated cord should be used. Cords rated for
less amperage may overheat. Care should be taken to arrange the cord so that it cannot be pulled
or tripped over.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
When using your heat press,
basic precautions should always be followed,
including the following:
Safety Instructions
Product Warranty Registration
Log onto www.Hotronix.com/registration
You must provide the Hotronix
®
heat press
serial number and model information.
H O T R O N I X . C O M
The MAXX
™
Press
Safety Instructions
Machine View
Control Panel Guide
Operating Instructions
Connecting the System
Turning the System On
Adjusting the Temperature
Adjusting the Time
Adjusting the Pressure
Pressing
Replacement Parts List
Parts Location Guide
Electrical Schematic
Contact
2
4
5
6-11
6
7
8
9
10
11
12
13
14
15
Table of Contents
ON OFF
S E R V I C E H O T L I N E : 8 0 0 . 7 2 7 . 8 5 2 0
The MAXX
™
Press
PAGE 4
FRONT VIEW
SIDE VIEW
LED Display
Lift Handle
Over-the-Center
Pressure Adjustment Knob
Machine View
Power ON/OFF Switch
Located in the Back
of the Press
Circuit Breaker
Power Supply
MO
M
H O T R O N I X . C O M
The MAXX
™
Press
P A G E 5
Digital Display
Temperature Indicator
Set Indicator
Time Indicator
Increase
Mode Select
Decrease
MODE
MODE
MODE
T
S
T
M
D
Control Panel Guide
Loading...