STV6110A
8PSK/QPSK low-power 3.3 V satellite tuner IC
Data Brief
Features
■ RF to baseband 8PSK/QPSK direct conversion
■ Single 3.3 V DC supply
■ Input frequency range 950 MHz to 2150 MHz
■ Supports 1 to 45 Msymbol/s
■ On-chip RF loop-through
■ Fully integrated PLL frequency synthesizer for
DVB-S2 (including loop filter)
■ Extremely low phase noise compliant with
DVB-S2 requirements
■ Low external component count
■ Low power consumption
■ Flexible crystal frequency output to drive the
demodulator IC
■ Continuously variable gain: 0 to 65 dB
■ Additional and programmable gain on
baseband amplifier: 0 to 16 dB
■ Programmable 5- to 36-MHz cut-off frequency
(butterworth 5th-order baseband filters)
■ Compatible with 5-V and 3.3 V I
2
C bus
Description
The STV6110A satellite tuner is a directconversion (zero IF) receiver dedicated to digital
TV broadcasting.
On the RF input is a low noise amplifier (LNA),
with buffer to supply the RF output for
loop-through, and a continuously variable gain
LNA to ensure an optimal signal level for the two
mixers. Each mixer, which down-converts the
signal to baseband, is followed by a low-pass filter
and amplifier. The baseband gain can be varied
by programming a register via the I
The LO signals are provided by an integrated PLL
which contains an on-chip voltage controlled
oscillator (VCO) meetin g string ent pha se noi se
requirements. The PLL loop filter is integrated.
The LO frequencies are programmable.
The comparison frequency for the phasefrequency detector (PFD) is generated by dividing
the crystal oscillator reference frequency. The
crystal frequency can be from 16 MHz to 32 MHz
depending on application.
2
C bus.
RF_OUT
RF_IN
AGC
PLL, dividers
XTAL_IN
XTAL_INN
XTAL_OUT
August 2008 Rev 1 1/5
For further information contact your local STMicroelectronics sales office.
Amplifier
DC offset compensation
2
C bus interface
I
IP
IN
QP
QN
SCL
SDA
www.st.com
5
Application STV6110A
1 Application
Figure 1. Application diagram for DVB-S2 front-end system
Choke
STV6110A
SatTuner
RF_IN
15 Ω
SDA, SCL
AGC
IN,IP
QN,QP
XTAL_OUT
27 MHz
LNBH23
I2C
16 MHz
DISEQC-RX
STV0903
SDAT, SCLT
AGCRF
IM,IP
QM,QP
XTAL_IN
DISEQC_IN
DISEQC_OUT
AUX_CLK
C
MPEG-4 / H.264
STx7100 or
STx7109
Decoder IC
2
I
2/5
STV6110A Ordering information
2 Ordering information
Table 1. Ordering information
Order code Packaging
STV6110A QFN32 5 x 5 mm
3/5
Revision history STV6110A
3 Revision history
Table 2. Document revision history
Date Revision Changes
21-Aug-2008 1 Initial release.
4/5
STV6110A
I
e
r
y
t
A
P
o
l
N
is
d
ts
o
h
t
U
D
W
D
W
S
O
U
T
R
G
A
Y,
D
E
G
R
id
a
y
l
Please Read Carefully:
nformation in this document is pro vided solely in connection with ST products . STMicroelec tronics NV and it s subsidiari es (“ST”) res erve th
ight to make changes , cor rections, modifications or i mproveme nt s, to th is documen t, and the prod ucts an d s ervices desc rib ed her ein at an
ime, without notice.
ll ST products are sold pursuant to ST’s terms and conditions of sale.
urchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes n
iability whatsoever relating to the choice, selection or use of the ST products and services described herein.
o license, express or implied, by estoppel or otherwise, to any intellectual property righ ts is granted under this document. If any part of th
ocument refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party produc
r services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of suc
hird party products or services or any intellectual property contained therein.
NLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIE
ARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIE
ARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAW
F ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
NLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NO
ECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAININ
PPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAI LURE OR MALFUNCTION MAY RESULT IN PERSONAL INJUR
EATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIV
RADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
esale of ST products with provisions diff erent from the sta tements and/ or technical fea tures set fort h in this document s hall immediat ely vo
ny warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, an
iability of ST.
The ST logo is a registered trade mark of STMicroelectronics. All other names are the property of their respect i ve owners.
ST and the ST logo are trademark s or registered trademarks of ST in various countries.
Information in this document su persedes and replaces all information pre viously supplied.
© 2008 STMicroelectronics - All rights reserv ed
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
STMicroelectronics group of companies
Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com
5/5
Loading...