ST STV0903 User Manual

for satellite digital TV and data services set-top boxes

Features

–DIRECTV – DVBS2 QPSK and 8PSK – Digital Nyquist root filter with 0.20, 0.25,
0.35 excess bandwidth factors
Decoding
– Up to 95 mega channel bits per second
(Mcbps) at input to DVBS2 FEC
– Up to 130 Mcbps DVBS or DIRECTV
input to legacy FEC
Interfaces
– Dedicated 27 MHz clock generation for
back-end decoder
2
–I
C serial bus interface
– JTAG interface - boundary scan
TM
and DVBS QPSK
STV0903
Multi-standard advanced demodulator
Data Brief
TM
2.x interface
2
C serial interface
TM
legacy and DVBS2 (QPSK and
TM
–DiSEqC – GPIOs and interrupt lines – Monitoring through I – FSK modem
Technology
– 90 nm CMOS process – Power saving features
Package
– LQFP-128-EP 14x14, 0.4 mm pitch, RoHS.
at

Description

STV0903 is a high performance satellite demodulator capable of handling DVB-S, DIRECTV 8PSK) constant coding and modulation signals for satellite broadcast.
AGCRF
[IN, IP]
[QN, QP]
XTALI
XTALO
SCL, SDA
SDAT, SCLT
DISEQCIN
DISEQCOUT
FSKRX_IN
FSKRX_OUT
GPIO[13:1]
TAP
D[7:0]
CLKOUT
STROUT
DPN
ERROR
Dual
8-bit ADC
Clock generation
Slave I2C manager
DiSEqCTM 2.0 manager
FSK manager
JTAG
boundary
scan
ASIC controller
and
power management
GPIO
switch matrix
Transport
stream manager
FIFO Line 1
IO and RF AGC
Multi-standard demodulator
Carrier
recovery
Lock indicator and
monitoring
DVBS2 FEC
LDPC decoder BCH decoder
DVBS2 de-framing CRC checker
loop
Multi roll-off nyquist and
interpolation
Timing
recovery
loop
filters
CNR
estimator
Legacy FEC
Viterbi decoder Inner de-interleaver
Reed-solomon decoder Energy descrambler
DVBS2
pilots
processor
and framing
Echo
concealment
equalizer
Demapper
August 2008 Rev 1 1/5
For further information contact your local STMicroelectronics sales office.
www.st.com
5
Application STV0903

1 Application

Figure 1. Application diagram for DVB-S2 front-end system
Choke
STV6110A
SatTuner
RF_IN
15
SDA, SCL
AGC
IN,IP
QN,QP
XTAL_OUT
27 MHz
LNBH23
I2C
16 MHz
DISEQC-RX
STV0903
SDAT, SCLT AGCRF
IM,IP
QM,QP
XTAL_IN
DISEQC_IN
DISEQC_OUT
AUX_CLK
C
STx7100 or STx7109
MPEG-4 / H.264
Decoder IC
2
I
2/5
STV0903 Ordering information

2 Ordering information

Table 1. Ordering information
Order code Packaging
STV0903BAB LQFP128-14 × 14 mm
3/5
Revision history STV0903

3 Revision history

Table 2. Document revision history
Date Revision Changes
21-Aug-2008 1 Initial release.
4/5
STV0903
I
e
r
y
t A P
o
l N
is
d
ts
o
h
t
U
D
W
D
W
S
O U
T
R
G
A
Y,
D
E
G
R
id
a
y
l
Please Read Carefully:
nformation in this document is pro vided solely in connection with ST products . STMicroelec tronics NV and it s subsidiari es (“ST”) res erve th ight to make changes , cor rections, modifications or improv eme nts, t o th is doc ument, and the prod uc ts an d serv ices des crib ed he rein a t an ime, without notice.
ll ST products are sold pursuant to ST’s terms and conditions of sale. urchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes n
iability whatsoever relating to the choice, selection or use of the ST products and services described herein.
o license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted unde r this document. If any part of th ocument refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party produc r services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of suc
hird party products or services or any intellectual property contained therein.
NLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIE
ARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIE ARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAW
F ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
NLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NO
ECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAININ
PPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAI LURE OR MALFUNCTION MAY RESULT IN PERSONAL INJUR
EATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIV
RADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
esale of ST products with provisions diff erent from the sta tements and/ or technical fea tures set fort h in this document s hall immediat ely vo ny warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, an
iability of ST.
The ST logo is a registered trade mark of STMicroelectronics. All other names are the property of their respective owners.
ST and the ST logo are trademark s or registered trademarks of ST in various countries.
Information in this document su persedes and replaces all informati on previously supplied.
© 2008 STMicroelectronics - All rights reserv ed
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
STMicroelectronics group of companies
Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United Stat es of America
www.st.com
5/5
Loading...