For further information contact your local STMicroelectronics sales office.
www.st.com
8
DescriptionSTDP8028
1 Description
The STDP8028 IC is an innovative System-on-Chip (SoC) controller designed for
multimedia monitors and emerging digital display applications.
This IC provides a complete multimedia LCD monitor solution chassis supporting worldwide
video and audio standards where exceptional quality is required.
The STDP8028 proficiently handles video and computer graphics inputs up to WUXGA
resolutions. The output port delivers unparalleled image quality and supports display
resolutions of up to WUXGA as well. Its rich feature set, high level of integration, and
sophisticated implemented technologies for color management, scaling, video processing
(Faroudja DCDi Cinema), and audio processing make STDP8028 the ideal answer for a
high-quality, cost-effective, integrated multimedia monitor solution.
2/8 Doc ID 15729 Rev 1
STDP8028Benefits
2 Benefits
●Complete SoC solution with exceptional video and audio quality
–Integrated x186-based microprocessor with rich function library
–General Purpose Inputs/Outputs (GPIOs) available for managing system devices
(keypad, backlight, NVRAM, etc.)
–2-wire serial master bus interface for external device control
–Integrated I/R decoder and 4-channel low bandwidth ADC
–Advanced bit-mapped OSD controller
●Output formats
–Dual-channel/single-channel 18/24/30-bit LVDS transmitters for direct connection
to LCD modules (applicable to STDP8028 only)
–Single-channel 24/30-bit TTL output
–Adaptive Contrast Ratio (ACR) control for automatic, intelligent backlight
adjustments
Doc ID 15729 Rev 15/8
Ordering informationSTDP8028
4 Ordering information
Table 1.Order codes
Part numberDescription
STDP8028-AB409-ball HSBGA
In order to meet environmental requirements, ST offers these devices in different grades of
ECOPACK® packages, depending on their level of environmental compliance. ECOPACK®
specifications, grade definitions and product status are available at: www.st.com.
ECOPACK® is an ST trademark.
6/8 Doc ID 15729 Rev 1
STDP8028Revision history
5 Revision history
Table 2.Document revision history
DateRevisionChanges
28-Apr-20091Initial release.
Updated features section to specify “receiver” when referring to
integrated HMDI 1.3 feature.
15-May-20092
Changed HDCP version from 1.3 to 1.2 and added “not supporting
Enhanced Verification Link and Advanced Cipher.”
Added the word “integrated” to feature heading “DisplayPort
1.1receiver”.
Doc ID 15729 Rev 17/8
STDP8028
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any
liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.