ST7MDT20-T6A/DVP
TQFP64 (10x10) Connection Kit for ST7MDT20-DVP3
DATA BRIEF
The TQFP64 (10x10) Connection Kit (ST7
MDT20-T6A/DVP) provides the hardware you
need to connect your ST7MDT20-DVP3 emulator
to your application when debugging applications
for ST7 microcontrollers in the TQFP64 (10x10)
package.
Connection Kit Contents
■ One additional 50-pin flat cable required for
connection between emulator and the adapter.
■ TQFP80/64/44 adapter (DB530) – Allows the
connection of your ST7MDT20-DVP3 emulator
to your application board in place of your ST7.
■ TQFP64 (10x10) device adapter (DB583) –
Adapts the emulator connection to the package
of your ST7.
■ Yamaichi TQFP64 (10x10) socket and cover
(IC149-064-075-B5) – solders to your
application board to allow connection of the
emulator or installation of your ST7.
For more information...
Figure 2. TQFP64 device adapter (DB583)
Figure 3. Connection to application board
Orientation
3. Plug flat cables into the
corresponding connectors
J1 and J2 on the adapter
Indicators
■ ST7-DVP3 User Manual – Information
common to all DVP3 series emulators
■ ST7MDT20-DVP3 Probe User Guide –
Information specific to ST7MDT20-DVP3
4. Plug the W1 and W2
connectors on the adapter
into the corresponding
connectors on the device
adapter.
Figure 1. Flat cable and adapter
Pin 1
Indicators
TQFP 80/64/44 Adapter (DB530)
Additional 50-pin flat cable
October 2005 1/3
2. Align pin 1 indicators,
then secure the device
adapter to the socket.
1. Solder socket to
application board.
Rev 1
www.st.com
3
ST7MDT20-T6A/DVP
Revision history
Date Revision Changes
10-October-2005 1 Initial release.
2/3