
Three phase controller for Intel MVP7 CPU power supply
Features
■ 4.5 V to 28 V input voltage range
■ 0.25 V to 1.52 V output voltage range, 8 bit
SVID
■ IMVP7 spec compliant
■ Selectable PWM switching frequency,
maximum temperature, maximum currents,
boot voltage, VID transitions slew rate slow
■ Adjustable load line (LL), 1 NTC needed for LL
thermal compensation
■ Lossless current sense with inductor DCR or
accurate inductor current sense with R
■
CkCOT (clocked constant on time control loop)
allows almost fixed pwm switching frequency
■ Output voltage ripple compensation
■ Phases overlap in load transient
■ Tunable overshoot threshold (TOT) allows to
reduce overshoot in load transient
■ Skip mode allows to increase efficiency at light
load
■ Average OCP for all phases and cycle by cycle
OCP for each phase
■ Embedded gate drivers and bootstrap diodes
■ Adjustable VID transitions feature
SENSE
PM6690
Data brief
QFN48 - 6x6
QFN-48
(exposed pad)
(7 x 7 mm)
Description
The PM6690 is a three phase step-down
switching controller with embedded gate drivers. It
has been designed to supply the CPU of the
®
Intel
mobile platform, according with INTEL
MVP7 specifications.
The controller is based on clocked constant ontime (CkCOT) architecture that allows nearly
constant switching frequency over load. The
controller ensures 120° phase shift PWM
operation when all the 3 phases are enabled.
An embedded integrator control loop
compensates the DC voltage error due to the
output voltage ripple. Load line of the output
voltage can be adjusted by setting a resistor
divider and it can be thermally compensated by
using 1 NTC.
Applications
■ Intel mobile
Table 1. Device summary
Order codes Package Packaging
PM6690
PM6690TR Tape and reel
®
CPU core IMVP7
QFN48 - 6x6
(exposed pad)
Tr ay
Current monitor IMON provides an analog output
current proportional to the CPU load current.
1NTC can be used to sense the maximum
temperature of the switching regulator and
provide the temperature information to the CPU
through SVID bus.
Adjustable VID transitions feature, TOT feature,
extremely low shutdown current and quiescent
current make the PM6690 a very flexible and
cost-effective solution for IMVP7 CPU power
supply.
March 2011 Doc ID 018638 Rev 1 1/3
For further information contact your local STMicroelectronics sales office.
www.st.com
3

Revision history PM6690
Revision history
Table 2. Document revision history
Date Revision Changes
29-Mar-2011 1 Initial release
2/3 Doc ID 018638 Rev 1

PM6690
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any
liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2011 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com
Doc ID 018638 Rev 1 3/3