ST PCC003V1 User Manual

Low-speed USB demonstration board based on the
STUSB03 transceiver and ST7263BE2 microcontroller
Features
– Based on the STUSB03, single chip USB
transceivers that support both USB full­speed and USB low-speed operations
– USB to mini-B cable
Software
– USB HID demonstration GUI
Description
STEVAL-PCC003V1
Data Brief
For demonstration purposes the USB microcontroller used is the ST72F63BE2 8-bit microcontroller. The STUSB03 connected with a USB controller is ideal for use in mobile phones, digital cameras, printers, PDAs, etc. All the hardware components except the transceiver IC are the same for the STEVAL-PCC003V1 and STEVAL-PCC004V1 demonstration boards. The demonstration board is comprised of one mini-B USB connector, a USB controller, a USB transceiver, two 2-to-4 demultiplexers and all required discrete components (pull-up resistors, series resistors and power supply capacitors). The device can be configured through a set of jumpers and the main signals can be accessed through test points. The demonstration board is powered from a USB mini-B or, optionally, from an external supply. The STUSB03 transceiver is connected at the USB communication lines of the microcontroller.
STEVAL-PCC003V1
August 2008 Rev 1 1/4
For further information contact your local STMicroelectronics sales office.
www.st.com
4
Circuit schematic STEVAL-PCC003V1

1 Circuit schematic

Figure 1. Schematic diagram

2/4
STEVAL-PCC003V1 Revision history

2 Revision history

Table 1. Document revision history

Date Revision Changes
18-Jul-2008 1 Initial release.
3/4
STEVAL-PCC003V1
y
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY, DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, an liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2008 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com
4/4
Loading...