
Features
STEVAL-ISA030V1
6 W 3-phase SMPS for metering evaluation board
based on ESBT
®
Data Brief
■ Input voltage: 150 V
■ Output power: 6 W
■ Output voltage: CH1: 14 V / 430 mA
■ Switching frequency: >30 kHz
■ Efficiency: >80%
■ Feedback: primary regulation
- 850 VDC
DC
Description
The STEVAL-ISA030V1 evaluation board is a
complete solution for a 5 W single output SMPS,
the type widely used as a power supply in
metering applications. The design is based
primarily on ST’s L6565 PWM driver and the
STC04IE170HP as the main switch. The design
method can also be applied to an SMPS designed
for other applications which work on a threephase mains, and can easily be upgraded for
higher output power.
STEVAL-ISA030V1
December 2007 Rev 1 1/4
For further information contact your local STMicroelectronics sales office.
www.st.com
4

Board schematic STEVAL-ISA030V1
1 Board schematic
Figure 1. Schematic
J2
Phoenix 2 pin12
R14
11K/ 1/8W
14V @ 0.43A
C1
330uF/25V
+
R15
1.2K/ 1/8W
R11
1.5K/ 1/8W
D3
STPS3L60U
A C
35T
7
6
7
6
T1
9T
C5
.0022uF
Y1 cap
12
43
ISO1
H11A817
R21
2.4K/ 1/8W
10nF
C7
R17
4.7K/ 1/8W
U2
TL431_ARC
R
A C
1
CSM 2010-104
1
R1
AC
STTH112U
STTH112U
D1
D2
D4 STTH112U
A C
M60 0X
L1
2
334
2
4
48T
100K /1206
A C
27T
R6
D6
R2
100K/ 1206
+
C2
33uF/450V
AC
D5
STTH112U
R8
1/ 1/8W
AC
LL4148
R3
R5
47k/ 1/ 8W
D7
R7
100K/ 1206
100K/ 1206
+
C3
33uF/450V
+
C4
33uF/450V
1M
R10
R9
AC
13
R12
R24
LL4148
100K/1206
100K/ 1206
Q1
STC04IE170 HP
4
2
10nF
C6
10/ 1206
R13
22/ 1206
2.2K/ 1206
6
5
7
8
GD
Vcc
U1
INV
L6565
1
GND
Vff
COMP2CS
3
4
ZCD
R22 330
+
+
R23
C11
C10
C9
C8
4.7/ 1/4W
22uF/25V
47uF/25V
4.7nF
3.3nF
R4
F1
TR5FU SE
1 2
123
J1
Phoenix 3 pin
1M
2/4
R18
22K

STEVAL-ISA030V1 Revision history
2 Revision history
Table 1. Document revision history
Date Revision Changes
06-Dec-2007 1 Initial release.
3/4

STEVAL-ISA030V1
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, an
liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2007 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com
4/4