ST ISA023V2 User Manual

STEVAL-ISA023V2
Flyback AC-DC converter evaluation board based on the VIPer53-E
with 24 W negative output
Data Brief
Features
Negative output voltage: -5 V,-12 V
Standby consumption: <1 W
Total output power: 24 W
EMI requirements: EN55022 Class B
Safety: EN 60950
rms
Description
This is an ideal solution for a 25 W switch mode power supply (SMPS) dedicated to industrial or white-goods applications. The board accepts a wide range of input voltages (90 to 265 Vrms) and delivers 2 negative output voltages. The switch­mode power supply(SMPS) is based on the VIPer53-E. The VIPer53-E combines an enhanced current-mode PWM controller with a high-voltage MDmesh™ Power MOSFET in the same package. The main characteristics of the evaluation board are its high efficiency and low standby consumption. These, combined with the minimal component count and global low cost approach, makes it an ideal solution for powering industrial or consumer equipment, while also meeting worldwide consumption requirements.
STEVAL-ISA023V2
December 2007 Rev 1 1/4
For further information contact your local STMicroelectronics sales office.
www.st.com
4
Board schematic STEVAL-ISA023V2

1 Board schematic

Figure 1. Scheme

CON2CON2
123
4
0
C18
100n
C18
100n
GND
L78L33U4L78L33
Vin Vout
C17
470n
C17
470n
U4
Negative version only
C15
C15
+
15k
15k
TL431U3TL431
0R
220RR7220R
C11
C11
+
+
Positive version only
3.3uHL23.3uH
L2
D6 STPS1045DD6 STPS1045D
7
1k
R141kR14
12
43
U2
PC817U2PC817
L3
D8 STPS2H100D8 STPS2H100
10
D9
9.1VD99.1V
R13
120R
R13
120R
100nF
100nF
470uF/25V
470uF/25V
C14
33uF/35V
C14
33uF/35V
C13
+
0.1uHL30.1uH
C9
470uF/25VC9470uF/25V
+
+
9
C13
+
+
R12
R12
R11
15k
R11
15k
C12
100nF
C12
100nF 10k
10k
R10
R10
U3
R90RR9
R80RR8
0R
R6
220RR6220R
R7
1000uF/25V
1000uF/25V
+
1000uF/25V
1000uF/25V
C10
C10
+
D7
STPS1045DD7STPS1045D
8
2.2nF/Y1
2.2nF/Y1
C16
C16
T1T1
1
t
t
RT1
RT1
15R
15R
4
3
D5
1.5KE150AD51.5KE150A
D4
STTH1R06D4STTH1R06
D1
D1
R11MR1
1M
20mH/1AL120mH/1A
L1
F12AF1
2A
D3
BAR18D3BAR18
C8
120pFC8120pF
Q1
BC807-40Q1BC807-40
D2 STPS1150D2 STPS1150
R3
C3
68uF/400VC368uF/400V
-+
-+
R21MR2
1M
C2
C1
1
CON1
CON1
5
7
U1
5.6kR35.6k
221
5 6
D
VIPer 53DIPU1VIPer 53DIP
100nF/275VAC/X2C2100nF/275VAC/X2
100nF/275VAC/X2C1100nF/275VAC/X2
Input 85 - 265VAC
Input 85 - 265VAC
R5
7.5kR57.5k
22uF/35VC722uF/35V
C7
S
3
S
4
COMP
1
VDD
TOVL
8
OSC
NC
2
6
C4
C6
150nFC6150nF
R4
5.1kR45.1k
C5
39nFC539nF
4.7nF/50VC44.7nF/50V
2/4
STEVAL-ISA023V2 Revision history

2 Revision history

Table 1. Document revision history

Date Revision Changes
03-Dec-2007 1 Initial release.
3/4
STEVAL-ISA023V2
y
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY, DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, an liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2007 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com
4/4
Loading...