2000 W universal motor control demonstration board
based on the STM8S103F2 MCU and T1235H Triac
Features
■ Input voltage range: 90-265 VAC, 50/60 Hz
■ 12 VDC / 5 VDC auxiliary power supply based
on the VIPer16L in buck converter topology
■ Total power consumption below 300 mW in
standby mode
■ Maximum output power: 2000 W
■ 20-pin, 8-bit STM8S103F2 MCU as main
controller
■ Employs zero-voltage switching (ZVS) to
synchronize MCU events with the voltage
mains
■ Motor driven by T1235H high-temperature
Triac in phase-angle control
■ 5 power levels and standby mode selectable by
potentiometer
■ 5 LEDs to display the power level of the board
■ “RUN” LED to indicate the board is functioning
■ Standard in-circuit programming connector
■ IEC 61000-4-4 pre-compliance test passed
(burst up to 8 kV)
■ IEC 61000-4-5 pre-compliance test passed
(surge up to 2 kV)
■ RoHS compliant
STEVAL-IHM029V1
Data brief
STEVAL-IHM029V1
The power supply circuitry is based on the
VIPer16L, an off-line converter with an 800 V
avalanche-rugged power section, operating at 60
kHz.
The STEVAL-IHM029V1 can control any universal
motor up to 2000 W, thanks to the T1235H, a 12 A
600 V high temperature Triac. The motor control
is based on phase-angle.
In order to limit the in-rush current and possible
current peaks, the demonstration board features a
soft-start routine and a smooth power change
function.
Description
The STEVAL-IHM029V1 is a low-cost universal
motor control demonstration board designed for
the home appliance market, with particular focus
on vacuum cleaners, food processors and power
tools.
The board passed the pre-compliance tests for
EMC directives IEC 61000-4-4 (burst up to 8 kV)
and IEC 61000-4-5 (surge up to 2 kV).
In standby mode, the STEVAL-IHM029V1 has an
overall standby power consumption below 300
mW.
This system features the 20-pin, 8-bit
STM8S103F2 microcontroller running at 16 MHz
(RC user-trimmable internal RC clock), featuring
4 KB of Flash memory, a 10-bit A/D converter,
8/16 bit timers, communication interfaces and 640
bytes E
June 2010 Doc ID 17284 Rev 1 1/4
For further information contact your local STMicroelectronics sales office.
2
PROM.
www.st.com
4
Schematic diagram STEVAL-IHM029V1
1 Schematic diagram
Figure 1. STEVAL-IHM029V1 circuit schematic
2/4 Doc ID 17284 Rev 1